Search results
Results from the WOW.Com Content Network
English: Graph shows the dissolved oxygen in mg/L at different depths in meters. Date: 14 October 2020: Source: ... Conversion program: Mac OS X 10.13.6 Quartz ...
In environmental chemistry, the chemical oxygen demand (COD) is an indicative measure of the amount of oxygen that can be consumed by reactions in a measured solution. It is commonly expressed in mass of oxygen consumed over volume of solution, which in SI units is milligrams per liter ( mg / L ).
The relative harsh environment inspires the potential of denitrifiers to degrade toxic nitrate or nitrite under an aerobic atmosphere. Aerobic denitrifiers tend to work efficiently at 25 ~ 37 °C and pH 7 ~ 8, when dissolved oxygen concentration is 3 ~ 5 mg/L and C/N load ratio is 5 ~ 10. [4]
This redox electrode (also known as dissolved oxygen sensor [27]) utilized an oxygen-permeable membrane to allow the diffusion of the gas into an electrochemical cell and its concentration determined by polarographic or galvanic electrodes. This analytical method is sensitive and accurate to down to levels of ± 0.1 mg/L dissolved oxygen.
The amount of dissolved oxygen is directly proportional to the titration of iodine with a thiosulfate solution. [1] Today, the method is effectively used as its colorimetric modification, where the trivalent manganese produced on acidifying the brown suspension is directly reacted with ethylenediaminetetraacetic acid to give a pink color. [ 2 ]
The solubility of oxygen in water is temperature-dependent, and about twice as much (14.6 mg/L) dissolves at 0 °C than at 20 °C (7.6 mg/L). [13] [50] At 25 °C and 1 standard atmosphere (101.3 kPa) of air, freshwater can dissolve about 6.04 milliliters (mL) of oxygen per liter, and seawater contains about 4.95 mL per liter. [51] At 5 °C the ...
where TDS is expressed in mg/L and EC is the electrical conductivity in microsiemens per centimeter at 25 °C. The conversion factor k e varies between 0.55 and 0.8. [5] Some TDS meters use an electrical conductivity measurement to the ppm using the above formula. Regarding units, 1 ppm indicates 1 mg of dissolved solids per 1,000 g of water. [6]
In 1888, while still a doctoral student, Lajos Winkler discovered a much safer, and more precise, method of dissolved-oxygen analysis, which is still widely used today. [5] The Winkler method uses the dissolved oxygen to convert manganese(II) hydroxide into manganese(III) species, and then analyzing for the latter by titration. [6]