Ads
related to: 25 pin connector to usb
Search results
Results from the WOW.Com Content Network
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
USB connector interfaces are classified into three types: ... (with 9 or 10 pins at connector interfaces; ID-pin is not wired) ... USB Type-C Rev. 2.1 2021-05-25
Mini-Centronics 36-pin male connector (top) with Micro ribbon 36-pin male Centronics connector (bottom) The Apple II Parallel Printer Port connected to the printer via a folded ribbon cable; one end connected to the connector at the top of the card, and the other end had a 36-pin Centronics connector.
[25] [27] The 24-pin double-sided connector provides four power–ground pairs, two differential pairs for USB 2.0 data (though only one pair is implemented in a USB-C cable), four pairs for SuperSpeed data bus (only two pairs are used in USB 3.1 mode), two "sideband use" pins, V CONN +5 V power for active cables, and a configuration pin for ...
The standard recommends the D-subminiature 25-pin connector up to revision C, and makes it mandatory as of revision D. Most devices only implement a few of the twenty signals specified in the standard, so connectors and cables with fewer pins are sufficient for most connections, more compact, and less expensive.
Additionally, USB ports are color-coded according to the specification and data transfer speed, e.g. USB 1.x and 2.x ports are usually white or black, and USB 3.0 ones are blue. SuperSpeed+ connectors are teal in color. [2] FireWire ports used with video equipment (among other devices) can be either 4-pin or 6-pin. The two extra conductors in ...
Later Macintosh models use 8-pin miniature DIN connectors instead. On PCs, 25-pin and (beginning with the IBM PC/AT) 9-pin plugs were used for the RS-232 serial ports; 25-pin sockets were used for parallel ports (instead of the Centronics port found on the printer itself, which was inconveniently large for direct placement on the expansion cards).
The Universal Connector was a standard port fitted to the bottom of many Palm PDAs from 2001 to 2004 and on units from other manufacturers that licensed Palm technology, including Garmin. Out of the box, it is used to connect to the sync and charge cradle, allowing the Palm to connect to a desktop PC and receive battery power.
Ads
related to: 25 pin connector to usb