Search results
Results from the WOW.Com Content Network
In optics, jitter is used to refer to motion that has high temporal frequency relative to the integration/exposure time. This may result from vibration in an assembly or from the unstable hand of a photographer. Jitter is typically differentiated from smear, which has a lower frequency relative to the integration time. [1]
Bufferbloat can also cause packet delay variation (also known as jitter), as well as reduce the overall network throughput. When a router or switch is configured to use excessively large buffers, even very high-speed networks can become practically unusable for many interactive applications like voice over IP (VoIP), audio streaming , online ...
Jitter period is the interval between two times of maximum effect (or minimum effect) of a signal characteristic that varies regularly with time. Jitter frequency, the more commonly quoted figure, is its inverse. ITU-T G.810 classifies deviation lower frequencies below 10 Hz as wander and higher frequencies at or above 10 Hz as jitter. [2]
This measurement quantifies the amount of 'frequency wobble' (caused by speed fluctuations) present in subjectively valid terms. Turntables tend to suffer mainly slow wow. In digital systems, which are locked to crystal oscillators, variations in clock timing are referred to as wander or jitter, depending on speed.
In electronic camera specifications frame rate refers to the maximum possible rate frames that can be captured (e.g. if the exposure time were set to near-zero), but in practice, other settings (such as exposure time) may reduce the actual frequency to a lower number than the frame rate. [18]
Temporal anti-aliasing (TAA) is a spatial anti-aliasing technique for computer-generated video that combines information from past frames and the current frame to remove jaggies in the current frame. In TAA, each pixel is sampled once per frame but in each frame the sample is at a different location within the frame.
A high-speed camera is a device capable of capturing moving images with exposures of less than 1 / 1 000 second or frame rates in excess of 250 frames per second. [1] It is used for recording fast-moving objects as photographic images onto a storage medium. After recording, the images stored on the medium can be played back in slow motion.
1.8×10 1: ENIAC, first programmable electronic digital computer, 1945 [2] 5×10 1: upper end of serialized human perception computation (light bulbs do not flicker to the human observer) 7×10 1: Whirlwind I 1951 vacuum tube computer and IBM 1620 1959 transistorized scientific minicomputer [2]