enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Head gasket - Wikipedia

   en.wikipedia.org/wiki/Head_gasket

   Head gasket with a leak between the rightmost and centre cylinders. A leak in the head gasket - often called a "blown head gasket" - can result in a leak of coolant, the combustion gasses, or both. Blue smoke from the exhaust suggests that excess oil is entering the combustion chambers (although there are other possible causes than a head ...

3. Oldsmobile V8 engine - Wikipedia

   en.wikipedia.org/wiki/Oldsmobile_V8_engine

   The 260 was designed for economy, and was the first engine option above the Chevrolet 250 straight-six, then later the 3.8 L Buick V6, which was standard fitment in many Oldsmobile models by the late 1970s. While the 260s were not very powerful compared to the larger 350 and 403 V8s, fuel economy was almost as good as the base V6.

4. Chevrolet small-block engine (first- and second-generation)

   en.wikipedia.org/wiki/Chevrolet_small-block...

   The 1973–1974 L82 was a "performance" version of the 350 that still used the casting number 624 76cc chamber "2.02" heads but with a Rochester Quadra-jet 4bbl carburetor and dual-plane aluminum intake manifold, the earlier L46 350 hp (261 kW) 350 hydraulic-lifter cam, and 9.0:1 compression forged-aluminum pistons producing 250 hp (186 kW ...

5. Rocker cover - Wikipedia

   en.wikipedia.org/wiki/Rocker_cover

   A rocker cover gasket (valve cover gasket in the US and Canada) is used to seal the joint between the cover and engine head. Failure of the gasket can cause oil to leak from the engine. A head gasket is used to seal the joint between the head and the engine block.

6. GM High Value engine - Wikipedia

   en.wikipedia.org/wiki/GM_High_Value_engine

   The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.

7. Chevrolet K5 Blazer - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_K5_Blazer

   To achieve the 9.2:1 compression ratio, the cylinder head chambers were smaller, measuring 56 cc instead of 76 cc. After 1987, when throttle-body injection was introduced in the truck engines, the 350 was made the standard power plant. Corporate 10-bolt axles were upgraded to 30 spline axle shafts from previous 28 spline shafts in 1989.