enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Product detector - Wikipedia

    en.wikipedia.org/wiki/Product_detector

    A product detector is a type of demodulator used for AM and SSB signals. Rather than converting the envelope of the signal into the decoded waveform like an envelope detector, the product detector takes the product of the modulated signal and a local oscillator, hence the name.

  3. Amplitude modulation - Wikipedia

    en.wikipedia.org/wiki/Amplitude_modulation

    Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave. In amplitude modulation, the amplitude (signal strength) of the wave is varied in proportion to that of the message signal, such as an audio signal .

  4. Frequency mixer - Wikipedia

    en.wikipedia.org/wiki/Frequency_mixer

    The mixer circuit can be used not only to shift the frequency of an input signal as in a receiver, but also as a product detector, modulator, phase detector or frequency multiplier. [6] For example, a communications receiver might contain two mixer stages for conversion of the input signal to an intermediate frequency and another mixer employed ...

  5. Radio transmitter design - Wikipedia

    en.wikipedia.org/wiki/Radio_transmitter_design

    When modulation is applied to the plate of the final tube, a large audio amplifier is needed for the modulation stage, equal to 1/2 of the DC input power of the modulated stage. Traditionally the modulation is applied using a large audio transformer. However many different circuits have been used for high level AM modulation. See Amplitude ...

  6. Armstrong phase modulator - Wikipedia

    en.wikipedia.org/wiki/Armstrong_phase_modulator

    Most people describe amplitude modulation as a method of changing the strength of the carrier (amplitude) in sync with the modulating audio. This is true, the power output does change with modulation, but it changes because any AM modulator generates two sidebands, one above and one below the carrier. As power goes into these sidebands, the ...

  7. Amplitude and phase-shift keying - Wikipedia

    en.wikipedia.org/wiki/Amplitude_and_phase-shift...

    A modified constellation diagram of 16-APSK. Typically 16-APSK will have 15 degree phase offset on the outer ring, which is not depicted here. Symbols can be easily distinguished from each other and, moreover, varying of the space between rings is a way to counteract transmission distortions. [4]

  8. Direct-conversion receiver - Wikipedia

    en.wikipedia.org/wiki/Direct-conversion_receiver

    A direct-conversion receiver (DCR), also known as homodyne, synchrodyne, or zero-IF receiver, is a radio receiver design that demodulates the incoming radio signal using synchronous detection driven by a local oscillator whose frequency is identical to, or very close to the carrier frequency of the intended signal.

  9. Compatible sideband transmission - Wikipedia

    en.wikipedia.org/wiki/Compatible_sideband...

    A Compatible sideband transmission, also known as amplitude modulation equivalent (AME) or Single sideband reduced-carrier (SSB-RC), is a type of single sideband RF modulation in which the carrier is deliberately reinserted at a lower level after its normal suppression to permit reception by conventional AM receivers. The general convention is ...