Search results
Results from the WOW.Com Content Network
A busy signal (or busy tone or engaged tone) in telephony is an audible call-progress tone or audible signal to the calling party that indicates failure to complete the requested connection of that particular telephone call. The busy signal has become less common in the past few decades due to the prevalence of call waiting and voicemail.
The reorder tone, also known as the fast busy tone, or the congestion tone, or all trunks busy (ATB) tone is an audible call progress tone in the public switched telephone network (PSTN) that is returned to a calling party to indicate that the call cannot be processed through the network.
Reproduction of an iOS phone disconnect tone (not the original audio) A disconnect tone in telephony is a tone provided to the remaining party to a call after the remote party hangs up. [ 1 ] [ 2 ] Typically, the disconnect tone is a few cycles of the reorder , busy , or the off-hook tone (e.g. in US), or between five and fifteen seconds of the ...
In many cases, when calling from abroad, busy, reorder and other call failure tones may be played by the local switch. Modern signalling protocols like SS7 send this information digitally; thus only a ringback tone or announcement generated by a distant switch in a foreign network will ever be heard by callers from other countries or networks.
The fast busy signal is generally twice as fast as the normal busy signal. status tones such as STD notification tones (to inform the caller that the telephone call is being trunk dialled at a greater cost to the calling party), minute minder beeps (to inform the caller of the relative duration of the telephone call on calls that are charged on ...
1. Check phone line for dial tone, and line quality. 2, Redial. 3. Select a different access number(s). Access Numbers work better with certain modems.
In the past, the call would be forwarded to an intercept operator after usually two readings of the message; today, however, this procedure is not observed, and on some systems a fast busy signal follows the second reading of the message instead. (A busy or an Off-Hook may be used depending on the provider.)
Like a dial tone or busy signal, the SIT is an in-band signal intended both to be heard by the caller, and to be detected by automated dialing equipment to determine a call has failed. In North America, the AT&T/Bellcore SIT standard allows the frequency and duration of the tones to vary slightly - making eight distinct messages specifically ...