Search results
Results from the WOW.Com Content Network
The traditional decking material is pressure-treated wood. The current material many contractors choose to use is composite decking. This material is typically made from wood–plastic composite or fiberglass reinforced plastic (FRP). Such materials do not warp, crack, or split and are as versatile as traditional pressure treated wood.
The strength of materials is determined using various methods of calculating the stresses and strains in structural members, such as beams, columns, and shafts. The methods employed to predict the response of a structure under loading and its susceptibility to various failure modes takes into account the properties of the materials such as its yield strength, ultimate strength, Young's modulus ...
The turning rotation of a vessel about its vertical/Z axis. An offset or deviation from normal on this axis is referred to as deviation or set. This is referred to as the heading of the boat relative to a magnetic compass (or true heading if referenced to the true north pole); it also affects the bearing.
When testing wood in lumber form, the Janka test is always carried out on wood from the tree trunk (known as the heartwood), and the standard sample (according to ASTM D143) is at 12% moisture content and clear of knots. [3] The hardness of wood varies with the direction of the wood grain. Testing on the surface of a plank, perpendicular to the ...
The California Bearing Ratio (CBR) is a measure of the strength of the subgrade of a road or other paved area, and of the materials used in its construction. The ratio is measured using a standardized penetration test first developed by the California Division of Highways for highway engineering . [ 1 ]
Wood or timber decking ... Guard rails have a specific building code requirement for both height and structural strength. Most U.S. commercial building codes require ...
The bearing capacity of soil is the maximum average contact pressure between the foundation and the soil which should not produce shear failure in the soil. Ultimate bearing capacity is the theoretical maximum pressure which can be supported without failure; allowable bearing capacity is the ultimate bearing capacity divided by a factor of ...
LVL can also be used in combination with gluelam as an outer gluelam tension lam to increase the strength of the gluelam beam. [1] However, due to the fact that the assembly adhesives limit the penetration of chemicals typically used to treat outdoor-rated lumber, LVL may not be suitable for outdoor load-bearing use — rotten LVL joists were ...