enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. SWR meter - Wikipedia

    en.wikipedia.org/wiki/SWR_meter

    An SWR meter does not measure the actual impedance of a load (the resistance and reactance), but only the mismatch ratio. To measure the actual impedance requires an antenna analyzer or other similar RF measuring device. For accurate readings, the SWR meter itself must also match the line's impedance (typically 50 or 75 Ohms).

  3. Standing wave ratio - Wikipedia

    en.wikipedia.org/wiki/Standing_wave_ratio

    SWR is usually measured using a dedicated instrument called an SWR meter. Since SWR is a measure of the load impedance relative to the characteristic impedance of the transmission line in use (which together determine the reflection coefficient as described below), a given SWR meter can interpret the impedance it sees in terms of SWR only if it ...

  4. Antenna analyzer - Wikipedia

    en.wikipedia.org/wiki/Antenna_analyzer

    An antenna analyzer measuring SWR and complex impedance of a dummy load. MFJ-269, MFJ Enterprises Inc. An antenna analyzer or in British aerial analyser (also known as a noise bridge, RX bridge, SWR analyzer, or RF analyzer) is a device used for measuring the input impedance of antenna systems in radio electronics applications.

  5. Field strength meter - Wikipedia

    en.wikipedia.org/wiki/Field_strength_meter

    When measuring with a field strength meter it is important to use a calibrated antenna such as the standard antenna supplied with the meter. For precision measurements the antenna must be at a standard height. A value of standard height frequently employed for VHF and UHF measurements is 10 metres (33 ft). Gain correction tables may be provided ...

  6. Antenna tuner - Wikipedia

    en.wikipedia.org/wiki/Antenna_tuner

    Cross-needle SWR meter on antenna tuner. It is a common misconception that a high standing wave ratio (SWR) per se causes loss. [3] A well-adjusted ATU feeding an antenna through a low-loss line may have only a small percentage of additional loss compared with an intrinsically matched antenna, even with a high SWR (4:1, for example). [21]

  7. Antenna measurement - Wikipedia

    en.wikipedia.org/wiki/Antenna_measurement

    Antenna directivity is the ratio of maximum radiation intensity (power per unit surface) radiated by the antenna in the maximum direction divided by the intensity radiated by a hypothetical isotropic antenna radiating the same total power as that antenna. For example, a hypothetical antenna which had a radiated pattern of a hemisphere (1/2 ...

  8. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  9. Citizens band radio - Wikipedia

    en.wikipedia.org/wiki/Citizens_band_radio

    Over the next several years antenna regulations were relaxed, with antenna length increasing to 1.65 meters (5'5") and centre- or top-loading of the main radiating element permitted. On 1 September 1987 the UK added the usual 40 frequencies (26.965–27.405 MHz) used worldwide, for a total of 80 channels at 27 MHz; antenna regulations were ...