enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Registered jack - Wikipedia

   en.wikipedia.org/wiki/Registered_jack

   A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

3. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   An 8P8C modular plug. This is the common crimp-type plug, of the same kind pictured above crimped onto a cable (with molded sleeve). A modular connector is a type of electrical connector for cords and cables of electronic devices and appliances, such as in computer networking, telecommunication equipment, and audio headsets.

4. GG45 - Wikipedia

   en.wikipedia.org/wiki/GG45

   GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions. [2]

5. Patch cable - Wikipedia

   en.wikipedia.org/wiki/Patch_cable

   The cables could get tangled or mixed up, and it would be hard to know, when faced with 20 connectors at the end of the cable run, which cable was associated with which microphone or instrument. The patch panel is numbered, so that the engineer can note which microphone or instrument is plugged into each numbered connection.

6. Ethernet physical layer - Wikipedia

   en.wikipedia.org/wiki/Ethernet_physical_layer

   A standard 8P8C (often called RJ45) connector used most commonly on category 5 cable, one of the types of cabling used in Ethernet networks Standard IEEE 802.3 (1983 onwards) Physical media Twisted pair, optical fiber, coaxial cable Network topology Point-to-point, star, bus Major variants

7. Keystone module - Wikipedia

   en.wikipedia.org/wiki/Keystone_module

   Some keystones use a pass-through type connector, where there is a jack on both the front face and the rear side. Others only have a jack on the front and employ a different mechanism for hard-wiring signal cables to the rear, such as a mini 110 block , an insulation-displacement connector , or a crimp or solder connection.