Search results
Results from the WOW.Com Content Network
The left-hand screw holding a circular saw blade or a bench grinder wheel on. In some devices that have threads on either end, like turnbuckles and removable pipe segments. These parts have one right-handed and one left-handed thread, so that turning the piece tightens or loosens both threads at the same time.
A spring pin (also called tension pin or roll pin) is a mechanical fastener that secures the position of two or more parts of a machine relative to each other. Spring pins have a body diameter which is larger than the diameter of the hole they are intended for, and a chamfer on either one or both ends to facilitate starting the pin into the hole.
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."
A screw displacement (also screw operation or rotary translation) is the composition of a rotation by an angle φ about an axis (called the screw axis) with a translation by a distance d along this axis. A positive rotation direction usually means one that corresponds to the translation direction by the right-hand rule. This means that if the ...
Helices are either right or left handed with curled fingers giving the direction of rotation and thumb giving the direction of advance along the z-axis. The threads of a screw are helical and therefore screws can be right- or left-handed. To properly fasten or unfasten a screw, one applies the above rules: if a screw is right-handed, pointing ...
In kinematics, Chasles' theorem, or Mozzi–Chasles' theorem, says that the most general rigid body displacement can be produced by a screw displacement. A direct Euclidean isometry in three dimensions involves a translation and a rotation .
In oil field tubing, buttress thread is a pipe thread form designed to provide a tight hydraulic seal. The thread form is similar to that of Acme thread [10] but there are two distinct threaded portions of differing diameters and profiles, the larger having a wedging profile, with a tapered sealing portion in between the larger and smaller diameters.
Control is by a small three-way steam valve (“forward”, “stop”, “back”) and a separate indicator showing the position of the rod and thus the percentage of cutoff in use. When the steam valve is at “stop”, an oil cock connecting the two ends of the locking piston is also closed, thus holding the mechanism in position.