Search results
Results from the WOW.Com Content Network
Pulse-amplitude modulation (PAM) is a form of signal modulation where the message information is encoded in the amplitude of a series of signal pulses. It is an analog pulse modulation scheme in which the amplitudes of a train of carrier pulses are varied according to the sample value of the message signal. Demodulation is performed by ...
Pulse-amplitude modulation: L: Pulse-width modulation (e.g. as used by WWVB) M: Pulse-position modulation: N: Unmodulated carrier (steady, single-frequency signal) P: Sequence of pulses without modulation Q: Sequence of pulses, with phase or frequency modulation in each pulse R: Single-sideband with reduced or variable carrier: V: Combination ...
A pulse wave or pulse train or rectangular wave is a non-sinusoidal waveform that is the periodic version of the rectangular function. It is held high a percent each cycle called the duty cycle and for the remainder of each cycle is low. A duty cycle of 50% produces a square wave, a specific case of a rectangular wave. The average level of a ...
Pulse-width modulation (PWM), also known as pulse-duration modulation (PDM) or pulse-length modulation (PLM), [1] is any method of representing a signal as a rectangular wave with a varying duty cycle (and for some methods also a varying period). PWM is useful for controlling the average power or amplitude delivered by an electrical signal.
Trellis-coded pulse-amplitude modulation (TC-PAM) is the modulation format that is used in HDSL2 and G.SHDSL.It is a variant of trellis coded modulation (TCM) which uses a one-dimensional pulse-amplitude modulation (PAM) symbol space, as opposed to a two-dimensional quadrature amplitude modulation (QAM) symbol space. [1]
Servo and receiver connections A diagram showing typical PWM timing for a servomotor. Servo control is a method of controlling many types of RC/hobbyist servos by sending the servo a PWM (pulse-width modulation) signal, a series of repeating pulses of variable width where either the width of the pulse (most common modern hobby servos) or the duty cycle of a pulse train (less common today ...
Amplitude modulation (AM) is a modulation technique used in electronic communication, most commonly for transmitting messages with a radio wave.In amplitude modulation, the amplitude (signal strength) of the wave is varied in proportion to that of the message signal, such as an audio signal.
Radar Pulse Train. The carrier is an RF signal, typically of microwave frequencies, which is usually (but not always) modulated to allow the system to capture the required data. In simple ranging radars, the carrier will be pulse modulated and in continuous wave systems, such as Doppler radar, modulation may not be required