Search results
Results from the WOW.Com Content Network
SIMM modules connect to the computer via an 8-bit- or 32-bit-wide interface. RIMM modules used by RDRAM are 16-bit- or 32-bit-wide. [49] DIMM modules connect to the computer via a 64-bit-wide interface. Some other computer architectures use different modules with a different bus width.
The modern DE-15 connector can carry Display Data Channel to allow the monitor to communicate with the graphics card, and optionally vice versa. [1] Being replaced by DVI from 1999 onward. DB13W3: Analog computer video, color and monochrome. Sun Microsystems, Silicon Graphics, IBM RISC, Intergraph and some Apple Computer computer workstations.
In general, cable lengths up to 4.5 metres (15 ft) will work for display resolutions up to 1920 × 1200. Longer cables up to 15 metres (49 ft) in length can be used with display resolutions 1280 × 1024 or lower.
Each 1000BASE-T network segment is recommended to be a maximum length of 100 meters (330 feet), [5] [a] and must use Category 5 cable or better (including Cat 5e and Cat 6). Autonegotiation is a requirement for using 1000BASE-T [6] according to Section 28D.5 Extensions required for Clause40 (1000BASE-T). [7]
Networking cable is a piece of networking hardware used to connect one network device to other network devices or to connect two or more computers to share devices such as printers or scanners. Different types of network cables, such as coaxial cable , optical fiber cable , and twisted pair cables, are used depending on the network's topology ...
10 Gigabit Ethernet (abbreviated 10GE, 10GbE, or 10 GigE) is a group of computer networking technologies for transmitting Ethernet frames at a rate of 10 gigabits per second. It was first defined by the IEEE 802.3ae-2002 standard.
The physical-layer specifications of the Ethernet family of computer network standards are published by the Institute of Electrical and Electronics Engineers (IEEE), which defines the electrical or optical properties and the transfer speed of the physical connection between a device and the network or between network devices.
A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...