Search results
Results from the WOW.Com Content Network
Key Seated Stuck Pipe. Key seating occurs when the drill string becomes off-centered in the wellbore, and the pipe collars become caught on a deviation in the wellbore. If the rig is able to move the drill string freely downhole, but every time the drill string is pulled upward it becomes stuck at the same point, then it is likely that the pipe ...
A screw extractor held in a tap wrench. A screw extractor is a tool for removing broken or seized screws.There are two types: one has a spiral flute structure, commonly called an easy out after the trademarked name EZ-Out; [clarification needed] the other has a straight flute structure.
Screw clamps consist of a band, often galvanized or stainless steel, into which a screw thread pattern has been cut or pressed. One end of the band contains a captive screw. The clamp is put around the hose or tube to be connected, with the loose end being fed into a narrow space between the band and the captive screw.
Insert nut, a type of en type of threaded insert for wood; Sex bolt, a type of nut with a low shoulder (flange) to provide resistance with little protrusion; T-nut, a nut that can be knocked into the back of a wood plate to provide a screw mounting hole; Wood hanger screw, a screw with machine threads in one end, and wood screw threads in the other
An ASME B18.2.1 compliant cap screw has somewhat tighter tolerances than a hex bolt for the head height and the shank length. The nature of the tolerance difference allows an ASME B18.2.1 hex cap screw to always fit where a hex bolt is installed but a hex bolt could be slightly too large to be used where a hex cap screw is designed in.
A wood screw is a metal screw used to fix wood, with a sharp point and a tapered thread designed to cut its own thread into the wood. Some screws are driven into intact wood; larger screws are usually driven into a hole narrower than the screw thread, and cut the thread in the wood.
Where a fastener forms its own thread in the component being fastened, it is called a screw. [3] This is most obviously so when the thread is tapered (i.e. traditional wood screws), precluding the use of a nut, [3] or when a sheet metal screw or other thread-forming screw is used. A screw must always be turned to assemble the joint.
On a shaft, this may be simply a flattened area. A set screw may have any type of drive, such as hex or square head, slot, or recessed --- cross (Phillips), hex (Allen), star (Torx), or square (Robertson). In the UK, the term "set screw" or "setscrew" refers simply to a bolt which is fully threaded, with no smooth shank; called cap screw in the US.