Search results
Results from the WOW.Com Content Network
The following formulas can be used to calculate the volumes of solute (V solute) and solvent (V solvent) to be used: [1] = = where V total is the desired total volume, and F is the desired dilution factor number (the number in the position of F if expressed as "1/F dilution factor" or "xF dilution"). However, some solutions and mixtures take up ...
In pharmacology, the international unit (IU) is a unit of measurement for the effect or biological activity of a substance, for the purpose of easier comparison across similar forms of substances. International units are used to quantify vitamins and biologics ( hormones , some medications , vaccines , blood products and similar biologically ...
The equation can only be applied when the purged volume of vapor or gas is replaced with "clean" air or gas. For example, the equation can be used to calculate the time required at a certain ventilation rate to reduce a high carbon monoxide concentration in a room.
For example, on a certain monitor, the horizontal distance between the upper limits for parathyroid hormone in pmol/L and pg/mL may be 7 cm, with the mass concentration to the right. A molar concentration of, for example, 5 pmol/L would therefore correspond to a mass concentration located 7 cm to the right in the mass diagram, that is ...
Historically, the mole was defined as the amount of substance in 12 grams of the carbon-12 isotope.As a consequence, the mass of one mole of a chemical compound, in grams, is numerically equal (for all practical purposes) to the mass of one molecule or formula unit of the compound, in daltons, and the molar mass of an isotope in grams per mole is approximately equal to the mass number ...
Ratio Note 1X ― 1:10 described as low potency 2X 1C 1:100 called higher potency than 1X by homeopaths 6X 3C 10 −6: 8X 4C 10 −8: 12X 6C 10 −12: 24X 12C 10 −24: Has a 60% probability of containing one molecule of original material if one mole of the original substance was used. 26X 13C 10 −26
In atmospheric chemistry, mixing ratio usually refers to the mole ratio r i, which is defined as the amount of a constituent n i divided by the total amount of all other constituents in a mixture: = The mole ratio is also called amount ratio. [2]
This ratio is therefore a comparison of the solubilities of the solute in these two liquids. The partition coefficient generally refers to the concentration ratio of un-ionized species of compound, whereas the distribution coefficient refers to the concentration ratio of all species of the compound (ionized plus un-ionized). [1]