Search results
Results from the WOW.Com Content Network
Thus, the outer diameter of a catheter in millimeters can be calculated by dividing the French size by 3. [2] For example, a catheter with a French size of 9 would have an outer diameter of approximately 3.07 mm. While the French scale aligns closely with the metric system, it introduces redundancy and the potential for rounding errors.
The pitch of 0BA is 1 mm and the pitch of each higher numbered thread is obtained by multiplying the pitch of the lower number by 0.9 so K-BA has a pitch of p = 0.9 K [4]: 12 rounded to two significant figures in mm. The major diameter is given by 6p 1.2, [4]: 12 rounded to two significant figures in mm and the hex head size (across the flats ...
Works with 15 mm miniatures where a 6 foot man would equal 15.24 mm 1:110: 2.771 mm Used for some model ships, aircraft and diecast cars. 1:108: 2.822 mm An historic size for ships, also used for rockets and spacecraft. 15 mm figure scale for wargaming is considered interchangeable with this scale. [9] 1:100: 3.048 mm
The .24 caliber (6 mm) cartridge version became known as the 6mm Bench Rest or the 6mm BR due to its widespread use in the sport of bench rest shooting. Because the cartridge was a wildcat and was not standardized until several years later, several variations of the cartridge existed.
40 mm 1.575 Ordnance QF 3-pounder Vickers: Naval gun 47 mm 1.85 inch Ordnance QF 6-pounder: Anti-tank gun 57 mm 2.244 inch Ordnance BL 10-pounder Mountain gun: Mountain gun 69.8 mm 2.75 inch 12-pounder (multiple types) Light field gun 76.2 mm 3 inch Ordnance QF 13-pounder: Light field gun 76.2 mm 3 inch 15- pounder (multiple types) Field gun 76 ...
Height is measured in rack units, "U", with 1 U being 1.75 in (44.45 mm). This dimension refers to the subrack in which the card is to be mounted, rather than the card itself. A single card is 100 mm high. Taller cards add a 133.35 mm, so that a double height card is 233.35 mm high and a triple 366.7 mm high.
Example (metric fine): For M7.0×0.5, major minus pitch yields 6.5, which at 92.9% happens to be an example that pushes over the outer bound of the 90% ± 2 pp, but major minus pitch is still valid, although smaller drills (6.3 mm, 1 ⁄ 4, 6.4 mm) will work well.
A standard metric (concrete) block is 190 mm wide, 390 mm long, and 190 mm high, which allows for 10 mm mortar joints in between bricks, giving a standard unit size of 200 mm square by 400 mm long. [3] A standard metric brick is 90 by 57 by 190 mm; with 10 mm of mortar, that produces a standard unit of 100 mm x 200 mm. [3]