Search results
Results from the WOW.Com Content Network
A mobile phone signal (also known as reception and service) is the signal strength (measured in dBm) received by a mobile phone from a cellular network (on the downlink). Depending on various factors, such as proximity to a tower , any obstructions such as buildings or trees, etc. this signal strength will vary.
Weak signal strength can also be caused by destructive interference of the signals from local towers in urban areas, or by the construction materials used in some buildings causing significant attenuation of signal strength. Large buildings such as warehouses, hospitals and factories often have no usable signal further than a few metres from ...
−73 dBm: 50.12 pW "S9" signal strength, a strong signal, on the S meter of a typical ham or shortwave radio receiver: −80 dBm: 10 pW: −100 dBm: 0.1 pW: Minimal received signal power of wireless network (802.11 variants) −111 dBm: 0.008 pW = 8 fW: Thermal noise floor for commercial GPS single-channel signal bandwidth (2 MHz) −127.5 dBm ...
Cellular signal strength of -74dBm (or 66 asu) displayed on a smartphone.Also shown: signal bars of two cellular networks, and signal bars of a Wi-Fi network. In telecommunications, received signal strength indicator or received signal strength indication [1] (RSSI) is a measurement of the power present in a received radio signal.
A signal strength and readability report is a standardized format for reporting the strength of the radio signal and the readability (quality) of the radiotelephone (voice) or radiotelegraph (Morse code) signal transmitted by another station as received at the reporting station's location and by their radio station equipment. These report ...
A weak signal with signal strength of S2 corresponds to received power of -115 dBm or 0.40 microvolts RMS in 50 ohms on HF. A strong signal with signal strength of S8 corresponds to received power of -79 dBm or 25 microvolts RMS in 50 ohms on HF. Some signal generators are calibrated in dB above 1uV and have an output in emf.
Metering pulses (depending on the country, these are 50 Hz, 12 kHz or 16 kHz pulses sent by the exchange to payphones or metering boxes) are out-of-band (because they do not fall within the frequency range used by the telephony signal, which is 300 through 3400 Hz) and channel-associated. They are generally regarded as line signaling, although ...
In telecommunications, the carrier-to-noise ratio, often written CNR or C/N, is the signal-to-noise ratio (SNR) of a modulated signal. The term is used to distinguish the CNR of the radio frequency passband signal from the SNR of an analog base band message signal after demodulation. For example, with FM radio, the strength of the 100 MHz ...