enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Corrugated galvanised iron - Wikipedia

   en.wikipedia.org/wiki/Corrugated_galvanised_iron

   Corrugated galvanised iron (CGI) or steel, colloquially corrugated iron (near universal), wriggly tin (taken from UK military slang), pailing (in Caribbean English), corrugated sheet metal (in North America), zinc (in Cyprus and Nigeria) or custom orb / corro sheet (Australia), is a building material composed of sheets of hot-dip galvanised ...

3. Metal roof - Wikipedia

   en.wikipedia.org/wiki/Metal_roof

   A metal roof is a roofing system featuring metal pieces or tiles exhibiting corrosion resistance, impermeability to water, and long life. It is a component of the building envelope . The metal pieces may be a covering on a structural, non-waterproof roof, or they could be self-supporting sheets.

4. Sheet metal - Wikipedia

   en.wikipedia.org/wiki/Sheet_metal

   Oxygen, nitrogen or air is fed through the same nozzle from which the laser beam exits. The metal is heated and burnt by the laser beam, cutting the metal sheet. [20] The quality of the edge can be mirror smooth and a precision of around 0.1 mm (0.0039 in) can be obtained. Cutting speeds on thin 1.2 mm (0.047 in) sheet can be as high as 25 m ...

5. Pole building framing - Wikipedia

   en.wikipedia.org/wiki/Pole_building_framing

   Siding materials for a pole building are most commonly rolled-rib 29-gauge enameled steel cut to length in 32-or-36-inch (813 or 914 mm) widths attached using color-matched screws with rubber washers to seal the holes. However, any standard siding can be used, including T1-11, vinyl, lap siding, cedar and even brick.

6. Shear (sheet metal) - Wikipedia

   en.wikipedia.org/wiki/Shear_(sheet_metal)

   Large versions can cut sheet metal up to 12 gauge. [5] An alternative to the hand tools are hydraulically powered tools attached to heavy machinery. They are usually used to cut materials that are too bulky to be transported to a cutting facility, too big or dangerous for the hand tools and are stored at remote locations (e.g. mines, forests). [6]

7. Nail (fastener) - Wikipedia

   en.wikipedia.org/wiki/Nail_(fastener)

   These nails were known as cut nails because they were produced by cutting iron bars into rods; they were also known as square nails because of their roughly rectangular cross section. The cut-nail process was patented in the U.S. by Jacob Perkins in 1795 and in England by Joseph Dyer, who set up machinery in Birmingham. The process was designed ...