Search results
Results from the WOW.Com Content Network
A deaerating feed tank (DFT), often found in steam plants that propel ships, is located after the main condensate pump and before the main feed booster pump. It has these three purposes: Remove dissolved oxygen (“air”) from the condensate; Pre-heat the feedwater; Provide a storage/surge volume
Small compressed air powered breathing gas booster pump Haskell booster set up for charging rebreather cylinders from premix banks with low pressure compressor. A booster pump is a machine which increases the pressure of a fluid. It may be used with liquids or gases, and the construction details vary depending on the fluid.
In the process industry, a standard set of symbols is used to prepare drawings of processes. The instrument symbols used in these drawings are generally based on International Society of Automation (ISA) Standard S5.1; The primary schematic drawing used for laying out a process control installation. They usually contain the following information:
A hydraulic ram pump, ram pump, or hydram is a cyclic water pump powered by hydropower. It takes in water at one " hydraulic head " (pressure) and flow rate, and outputs water at a higher hydraulic head and lower flow rate.
Please introduce links to this page from ; try the Find link tool for suggestions. ( December 2015 ) Dry running protection , also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor , pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be ...
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
Submersible pumps are mounted on two vertical guide rails and seal onto a permanently fixed "duckfoot", which forms both a mount and also a vertical bend for the discharge pipe. For maintenance or replacement, submersible pumps are raised by a chain off of the duckfoot and up the two guide rails to the maintenance (normally ground) level.
A hydraulic manifold is a component that regulates fluid flow between pumps and actuators and other components in a hydraulic system. It is like a switchboard in an electrical circuit because it lets the operator control how much fluid flows between which components of a hydraulic machinery.