Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
A shingle roof in Zakopane, Poland. With an area of 6000 m 2 (1½ acres), it was one of the largest wooden shingle roofs in Europe. A roof’s shingles are a roof covering consisting of individual overlapping elements. These elements are typically flat, rectangular shapes laid in courses from the bottom edge of the roof up, with each successive ...
Each piece has a groove cut all along one edge, and a thin, deep ridge (the tongue) on the opposite edge. If the tongue is unattached, it is considered a spline joint. Birdsmouth joint: Also called a bird's beak cut, this joint used in roof construction. A V-shaped cut in the rafter connects the rafter to the wall-plate. [11] Cross lap
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
The Tomlinson Lumber Co sold pre-cut materials for a 34 by 50 feet (10 m × 15 m) dairy barn with a Gothic-arched roof supported by three-ply rafters in 1958 throughout Minnesota. [ 10 ] The first published plans by an architect for a Gothic-arch barn appeared in 1916.
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
A simple rafter roof consists of rafters that the rafter foot rest on horizontal wall plates on top of each wall. [3] The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple.