Search results
Results from the WOW.Com Content Network
Three new seal types were introduced in the 2nd Edition: dry running containment seals, non-contacting seals, and dual gas barrier seals. [4] Containment seals are the outer seal of Arrangement 2. In the 2nd Edition, containment seals can be used with a liquid buffer fluid, a gas buffer fluid or without a buffer fluid.
Indeed, many gas turbine engine seals leak by design. [4] Labyrinth seals are also found on pistons, which use them to store oil and seal against high pressure during compression and power strokes, as well as on non-rotating shafts. In these applications, it is the long and difficult path and the formation of controlled fluid vortices plus some ...
In mechanical engineering, an end-face mechanical seal (often shortened to mechanical seal) is a type of seal used in rotating equipment, such as pumps, mixers, blowers, and compressors. When a pump operates, the liquid could leak out of the pump between the rotating shaft and the stationary pump casing. Since the shaft rotates, preventing this ...
The function of a liquid-ring pump is similar to a rotary vane pump, with the difference being that the vanes are a rigid part of the rotor and churn a rotating ring of liquid to form the compression-chamber seal. They are an inherently low-friction design, with the rotor being the only moving part. Sliding friction is limited to the shaft ...
Gaskets and shaft seals were intended to limit the leakage of oil, but they were usually not expected to entirely prevent it. The blow-by gases would diffuse through the oil and then leak through the seals and gaskets into the atmosphere, causing air pollution and odors. The first refinement in crankcase ventilation was the road draught tube.
Electrohydraulic servo valves may consist of one or more stages. A single-stage servo valve uses a torque motor to directly position a spool valve. Single-stage servo valves suffer from limitations in flow capability and stability due to torque motor power requirements.
The purge gas is inert, i.e. by definition [1] non-combustible, or more precisely, non-reactive. The most common purge gases commercially available in large quantities are nitrogen and carbon dioxide. Other inert gases, e.g. argon or helium may be used. Nitrogen and carbon dioxide are unsuitable purge gases in some applications, as these gases ...
In the first few years after introduction, they became known as the "Slip-N-Slide Powerglide", due to the fluid coupling, as opposed to the mechanical coupling of a clutch-driven gearbox, and the "Positive-Pop transmission". This last is due to the characteristic "bump" or "pop" which occurs as the transmission is put into gear from neutral.