Search results
Results from the WOW.Com Content Network
A saw with teeth along only one edge, like a Western saw. These are supplied as either rip saw or cross-cut type blades. An advantage of this saw is that it is easy to use with a saw guide. "Kataba" translates from Japanese as "cutting on one side." Kataba saws are commonly used for larger work when a Ryoba saw is not suitable, or for flush ...
The term is also used currently to refer to a thin, flexible saw used to free sashes that have been painted shut. Carcass saw – an in-between of a tenon saw and a dovetail saw. Dovetail saw – a small backsaw used to cut dovetails. These saws will usually have a higher number of teeth per inch (around 15 - 20 T.P.I.) with teeth sharpened in ...
A swing saw is used for cross cutting wood in a sawmill, or for cutting ice off of a frozen body of waters. The saw is hung on a swinging arm, sometimes with a counterbalance weight. A swing saw is also sometimes called a cut-off trim saw in a mill for cutting right angle to the direction of the wood grain. A swing saw is a very dangerous tool ...
Disston Saw Works was an American company owned by Henry Disston that manufactured handsaws during the mid-19th to early 20th century in the Tacony neighborhood of Philadelphia. The company was initially named Keystone Saw Works and then Henry Disston & Sons, Inc.
Carcase saw: a term used until the 20th century for backsaws with 10–14 in (25–36 cm) long blades; Dovetail saw: a backsaw with a blade of 6–10 in (15–25 cm) length, for cutting intricate joints in cabinet making work;
A crosscut saw (thwart saw) is any saw designed for cutting wood perpendicular to (across) the wood grain. Crosscut saws may be small or large, with small teeth close together for fine work like woodworking or large for coarse work like log bucking, and can be a hand tool or power tool. The cutting edge of each tooth is angled in an alternating ...
Gasoline or kerosene powered drag saws were popular between the 1910s-1940s when chain saws became preferable. [5] They usually did 90 strokes of the saw per minute. [6] Most of all gasoline-engine-powered dragsaws were made in Portland, Oregon, United States. Steam-powered dragsaws utilized a piston hooked directly to the saw blade.
The most popular material for handles of hand saws is applewood; in the early 1900s 2,000,000 board feet of applewood were used annually for this purpose. [2] Sometimes cultures developed two main types of saw teeth: the cross cut saw teeth and the rip saw teeth. [citation needed] These cut into the wood using different mechanisms.