Search results
Results from the WOW.Com Content Network
Lift-off oversteer (also known as trailing-throttle oversteer, throttle off oversteer, or lift-throttle oversteer) is a form of sudden oversteer.While cornering, a driver who closes the throttle (by lifting a foot off the accelerator, hence the name), usually at a high speed, can cause such sudden deceleration that the vertical load on the tires shifts from rear to front, in a process called ...
On a fuel-injected engine, ignoring the throttle (no fuel) while starting permits electronic logic systems to produce the correct fuel mixture, often based on exhaust gases. Some fuel injection computers interpret "pumping" the throttle to indicate a flooded engine, and alter the fuel-air mixture accordingly.
In fuel injected engines, the throttle body is the part of the air intake system that controls the amount of air flowing into the engine, in response to driver accelerator pedal input in the main. The throttle body is usually located between the air filter box and the intake manifold, and it is usually attached to, or near, the mass airflow sensor.
This causes an incomplete burn which causes the fumes to explode in the exhaust system along with an audible pop or bang sound. This is a result of working equipment, and is unlikely to cause damage. A fuel-injected engine may backfire if an intake leak is present (causing the engine to run lean), or a fuel injection component such as an air ...
Pressure in cylinder pattern in dependence on ignition timing: (a) - misfire, (b) too soon, (c) optimal, (d) too late. In a spark ignition internal combustion engine, ignition timing is the timing, relative to the current piston position and crankshaft angle, of the release of a spark in the combustion chamber near the end of the compression stroke.
Ordinarily, the power is cut by partially closing a throttle. However, the extra work done in pulling air through the throttle reduces efficiency. If the fuel/air ratio is reduced, then lower power can be achieved with the throttle closer to fully open, and the efficiency during normal driving (below the maximum torque capability of the engine ...
A throttle position sensor (TPS) is a sensor used to monitor the throttle body valve position for the ECU of an engine. The sensor is usually located on the butterfly spindle/shaft, so that it can directly monitor the position of the throttle. More advanced forms of the sensor are also used.
The intake manifold vacuum, with wide open throttle, is lower in these conditions, which causes the PCV valve to open and the crankcase gases flow to the intake system. [13] The greater flow rate of intake air during these conditions means that a greater quantity of blow-by gases can be added to the intake system without compromising the ...