enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bis-tris propane - Wikipedia

    en.wikipedia.org/wiki/Bis-tris_propane

    Bis-tris propane, or 1,3-bis(tris(hydroxymethyl)methylamino)propane, also known as BTP, is a chemical substance that is used in buffer solutions. It is a white to off-white crystalline powder that is soluble in water. It has a wide buffering range, from 6 to 9.5 due to its two pK a values which are close in value.

  3. Tris - Wikipedia

    en.wikipedia.org/wiki/Tris

    The useful buffer range for tris (pH 7–9) coincides with the physiological pH typical of most living organisms. This, and its low cost, make tris one of the most common buffers in the biology/biochemistry laboratory. Tris is also used as a primary standard to standardize acid solutions for chemical analysis.

  4. Bis-tris methane - Wikipedia

    en.wikipedia.org/wiki/Bis-tris_methane

    Bis-tris methane, also known as BIS-TRIS or BTM, is a buffering agent used in biochemistry. Bis-tris methane is an organic tertiary amine with labile protons having a pKa of 6.46 at 25 °C. It is an effective buffer between the pH 5.8 and 7.2. Bis-tris methane binds strongly to Cu and Pb ions as well as, weakly, to Mg, Ca, Mn, Co, Ni, Zn and Cd ...

  5. Buffer solution - Wikipedia

    en.wikipedia.org/wiki/Buffer_solution

    Buffer capacity falls to 33% of the maximum value at pH = pK a ± 1, to 10% at pH = pK a ± 1.5 and to 1% at pH = pK a ± 2. For this reason the most useful range is approximately p K a ± 1. When choosing a buffer for use at a specific pH, it should have a p K a value as close as possible to that pH.

  6. Polyacrylamide gel electrophoresis - Wikipedia

    en.wikipedia.org/wiki/Polyacrylamide_gel...

    The buffer should also be unreactive and not modify or react with most proteins. Different buffers may be used as cathode and anode buffers, respectively, depending on the application. Multiple pH values may be used within a single gel, for example in DISC electrophoresis. Common buffers in PAGE include Tris, Bis-Tris, or imidazole.

  7. Tricine - Wikipedia

    en.wikipedia.org/wiki/Tricine

    Tricine is an organic compound that is used in buffer solutions. The name tricine comes from tris and glycine, from which it was derived. [1] It is a white crystalline powder that is moderately soluble in water. It is a zwitterionic amino acid that has a pKa1 value of 2.3 at 25 °C, while its pKa2 at 20 °C is 8.15. Its useful buffering range ...

  8. Good's buffers - Wikipedia

    en.wikipedia.org/wiki/Good's_buffers

    Good's buffers (also Good buffers) are twenty buffering agents for biochemical and biological research selected and described by Norman Good and colleagues during 1966–1980. [ 1 ] [ 2 ] [ 3 ] Most of the buffers were new zwitterionic compounds prepared and tested by Good and coworkers for the first time, though some ( MES , ADA , BES , Bicine ...

  9. Total ionic strength adjustment buffer - Wikipedia

    en.wikipedia.org/wiki/Total_ionic_strength...

    Total ionic strength adjustment buffer (TISAB) is a buffer solution which increases the ionic strength of a solution to a relatively high level. This is important for potentiometric measurements, including ion selective electrodes , because they measure the activity of the analyte rather than its concentration.