enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Roof pitch - Wikipedia

   en.wikipedia.org/wiki/Roof_pitch

   Roof pitch is the steepness of a roof expressed as a ratio of inch(es) rise per horizontal foot (or their metric equivalent), or as the angle in degrees its surface deviates from the horizontal. A flat roof has a pitch of zero in either instance; all other roofs are pitched .

3. Domestic roof construction - Wikipedia

   en.wikipedia.org/wiki/Domestic_roof_construction

   Building codes in the U.S. specify ventilation rates as a minimum of 1 sq ft (0.093 m 2) of opening per 150 sq ft (14 m 2) (1:150) with a ratio of 1:300 in some conditions. [8] Warm air rises, so ceiling insulation is designed to have a higher r-value and the insulation is often installed between the ceiling joists or rafters.

4. Flat roof - Wikipedia

   en.wikipedia.org/wiki/Flat_roof

   A study by Ducker International in 2005 identified the average cost per year of a metal roof to be US$3.2 per square metre ($0.30/sq ft) while single-ply roofs stood at $6.1/m 2 ($0.57/sq ft) and built-up roofing at $4.0/m 2 ($0.37/sq ft).

5. Reflective surfaces (climate engineering) - Wikipedia

   en.wikipedia.org/wiki/Reflective_surfaces...

   As part of the new efforts, DOE will install a cool roof, whenever cost-effective over the lifetime of the roof, during construction of a new roof or the replacement of an old one at a DOE facility. In October 2013, the United States Department of Energy ranked Cool Roofs as a 53 out of 100 (0 to 100 weighted average) for a cost-effective ...

6. Roof insurance: ACV vs. replacement cost - AOL

   www.aol.com/finance/roof-insurance-acv-vs...

   For example, if the replacement cost — not the amount that you paid for it originally, but the amount it would cost to replace it today — for your roof is $20,000, but the roof loses 5 percent ...

7. Square (unit) - Wikipedia

   en.wikipedia.org/wiki/Square_(unit)

   The square is an Imperial unit of area that is used in the construction industry in the United States and Canada, [1] and was historically used in Australia. One square is equal to 100 square feet. Examples where the unit is used are roofing shingles, metal roofing, vinyl siding, and fibercement siding products.