enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

3. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   Unified Coarse/Fine diameters and tap drill sizes (U.S. units) Unified Coarse/Fine tap drill sizes (U.S. units) Imperial Metric fastening size conversion charts; International Thread Standards; Conversion chart Whitworth/BSF/AF and metric Archived 2 May 2010 at the Wayback Machine; Spanner Jaw Sizes Additional information and spanner jaw size ...

4. Metric drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   In the U.S., fractional inch and gauge drill bit sizes are in common use. In nearly all other countries, metric drill bit sizes are most common, and all others are anachronisms or are reserved for dealing with designs from the US. The British Standards on replacing gauge size drill bits with metric sizes in the UK was first published in 1959.

5. Comparison of the imperial and US customary measurement ...

   en.wikipedia.org/wiki/Comparison_of_the_imperial...

   Comparison of current imperial, US and metric volume measures; Notes: Approximate values are denoted with ≈; Exact values are denoted with ≡; Definitions are marked in bold; Unit name Imperial measures US fluid measures US dry measures Metric measures fluid ounces Imperial fluid ounce (fl oz) ≡ 1 imp fl oz. ≈ 0.960 759 940 40 US fl oz

6. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including:

7. Metrication in the United States - Wikipedia

   en.wikipedia.org/wiki/Metrication_in_the_United...

   Metric signs and metric measurements were removed for the 2009 edition and replaced with an appendix of metric conversion tables. This is in marked contrast to the position in the (largely metric) United Kingdom , where metric road signs are prohibited by law (except for those denoting widths and height restrictions, which include both metric ...

8. British Standard Whitworth - Wikipedia

   en.wikipedia.org/wiki/British_Standard_Whitworth

   British Morris and MG engines from 1923 to 1955 were built using metric threads with bolt heads and nuts dimensioned for Whitworth spanners and sockets. [13] In 1919, Morris Motors took over the French Hotchkiss engine works which had moved to Coventry during the First World War. The Hotchkiss machine tools were of metric thread but metric ...

9. System of units of measurement - Wikipedia

   en.wikipedia.org/wiki/System_of_units_of_measurement

   A baby bottle that measures in three measurement systems—metric, imperial (UK), and US customary. Metric systems of units have evolved since the adoption of the first well-defined system in France in 1795. During this evolution the use of these systems has spread throughout the world, first to non-English-speaking countries, and then to ...