Search results
Results from the WOW.Com Content Network
Floor Area ratio is sometimes called floor space ratio (FSR), floor space index (FSI), site ratio or plot ratio. The difference between FAR and FSI is that the first is a ratio, while the latter is an index. Index numbers are values expressed as a percentage of a single base figure. Thus an FAR of 1.5 is translated as an FSI of 150%.
Gross leasable area (GLA) is the amount of floor space available to be rented in a commercial property. Specifically, gross leasable area is the total floor area designed for tenant occupancy and exclusive use, including any basements, mezzanines, or upper floors. It is typically expressed in square metres (although in some places such as the ...
The ratio between the floor area and the site area is generally known as the Floor Area Ratio (FAR, also called Plot Ratio and Floor Space Index). For example, a ten-story building on 10% of the site has the same floor area as a single-story building with 100% site coverage. [7]
A floor area ratio (FAR) typically describes non-residential development, based on the ratio of building floor space to land area, both using the same unit of measure. Additional analysis might estimate the number of buildings or building coverage based on the number of dwelling units per building, the number of stories and/or the building size ...
A complex shape can present more opportunities for heat loss through the building envelope. Reducing the number of exterior walls, along with a low vertical surface area to floor area ratio (VFAR) decreases heat loss potential. [8] Some architectural styles are closely associated with massing.
Each zone determines a building's shape and permitted uses. A building's shape is controlled by zonal restrictions on allowable floor area ratio and height (in absolute terms and in relation with adjacent buildings and roads). [12] These controls are intended to allow adequate light and ventilation between buildings and on roads. [12]
A residential area of Ikuri in Tampere, Finland. In certain residential areas, especially rural, large tracts of land may have no services whatever, such that residents seeking services must use a motor vehicle or other transportation, so the need for transportation has resulted in land development following existing or planned transport infrastructure such as rail and road.
Urban density is a very specific measurement of the population of an urbanized area, excluding non-urban land-uses. Non-urban uses include regional open space, agriculture and water-bodies. There are a variety of other ways of measuring the density of urban areas: Population density - the number of human persons per unit area