Search results
Results from the WOW.Com Content Network
The wheel and tire assembly attach to the hub or spindle of the knuckle where the tire/wheel rotates while being held in a stable plane of motion by the knuckle/suspension assembly. In the attached photograph of a double-wishbone suspension, the knuckle is shown attached to the upper control arm at the top and the lower control arm at the bottom.
Spindles or uprights - Jaguar left and Holden Gemini right The wheel spindle in the illustration is colored red. In an automobile, the wheel spindle, sometimes called simply the spindle, is the part of the suspension system that carries the hub for the wheel and attaches to the upper and lower control arms.
MacPherson strut suspension, track control arm coloured dark blue. In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over ...
Suspension is the system of tires, tire air, springs, shock absorbers and linkages that connects a vehicle to its wheels and allows relative motion between the two. [1] Suspension systems must support both road holding/handling and ride quality, [2] which are at odds with each other. The tuning of suspensions involves finding the right compromise.
A simple MacPherson strut suspension on the left front wheel of a rear-wheel drive vehicle. The front of the vehicle is at bottom right of the image. Upper green: Vehicle body/strut interface Red: Steering knuckle or hub carrier Blue: Lower control arm or track control arm Light blue: Steering gear tie rod or track rod Lower purple: Radius rod
4] The complete rear suspension assembly is carried in a steel crossbeam cradle (shown ghosted in the diagram below), which is attached to the vehicle body via four rubber vee-blocks and also carries the differential (blue) and inboard brakes (red). The rear wheels are located transversely by top links and wheel carriers (green) and lower links ...
Automotive suspension design is an aspect of automotive engineering, concerned with designing the suspension for cars and trucks. Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture
Front suspension of a race car — the caster angle is formed by the line between upper and lower ball joint An example of a chopper with a raked fork at an extreme caster angle The caster angle [ 1 ] or castor angle [ 2 ] is the angular displacement of the steering axis from the vertical axis of a steered wheel in a car , motorcycle ...