Search results
Results from the WOW.Com Content Network
A subnet mask encodes the same information as a prefix length but predates the advent of CIDR. In CIDR notation, the prefix bits are always contiguous. Subnet masks were allowed by RFC 950 [6] to specify non-contiguous bits until RFC 4632 [5]: Section 5.1 stated that the mask must be left contiguous. Given this constraint, a subnet mask and ...
A wildcard mask can be thought of as an inverted subnet mask. For example, a subnet mask of 255.255.255.0 (11111111.11111111.11111111.00000000 2) inverts to a wildcard mask of 0.0.0.255 (00000000.00000000.00000000.11111111 2). A wild card mask is a matching rule. [2] The rule for a wildcard mask is: 0 means that the equivalent bit must match
Subnet masks are also expressed in dot-decimal notation like an IP address. For example, the prefix 198.51.100.0 / 24 would have the subnet mask 255.255.255.0 . Traffic is exchanged between subnets through routers when the routing prefixes of the source address and the destination address differ.
The term subnet mask is only used within IPv4. Both IP versions however use the CIDR concept and notation. In this, the IP address is followed by a slash and the number (in decimal) of bits used for the network part, also called the routing prefix. For example, an IPv4 address and its subnet mask may be 192.0.2.1 and 255.255.255.0, respectively.
For IPv4, a network may also be characterized by its subnet mask or netmask, which is the bitmask that when applied by a bitwise AND operation to any IP address in the network, yields the routing prefix. Subnet masks are also expressed in dot-decimal notation like an address. For example, 255.255.255.0 is the subnet mask for the prefix 198.51 ...
The Internet Group Management Protocol (IGMP) is a communications protocol used by hosts and adjacent routers on IPv4 networks to establish multicast group memberships. IGMP is an integral part of IP multicast and allows the network to direct multicast transmissions only to hosts that have requested them.
A given router can have some interfaces that are designated (DR) and others that are backup designated (BDR), and others that are non-designated. If no router is a DR or a BDR on a given subnet, the BDR is first elected, and then a second election is held for the DR. [1]: 75