Search results
Results from the WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks. The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
A switch using store-and-forward transmission will receive (save) the entire packet to the buffer and check it for CRC errors or other problems before sending the first bit of the packet into the outbound link. Thus, store-and-forward packet switches introduce a store-and-forward delay at the input to each link along the packet's route.
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
L is the average packet length (e.g. in bits), and R is the transmission rate (e.g. bits per second) A traffic intensity greater than one erlang means that the rate at which bits arrive exceeds the rate bits can be transmitted and queuing delay will grow without bound (if the traffic intensity stays the same). If the traffic intensity is less ...
Processing delay – time it takes a router to process the packet header; Queuing delay – time the packet spends in routing queues; Transmission delay – time it takes to push the packet's bits onto the link; Propagation delay – time for a signal to propagate through the media; A certain minimum level of delay is experienced by signals due ...
Packet capture is the process of intercepting and logging traffic. As data streams flow across the network, the analyzer captures each packet and, if needed, decodes the packet's raw data, showing the values of various fields in the packet, and analyzes its content according to the appropriate RFC or other specifications.
The time-to-live (TTL) value, also known as hop limit, is used in determining the intermediate routers being traversed towards the destination. Traceroute sends packets with TTL values that gradually increase from packet to packet, starting with TTL value of one.
End-to-end delay or one-way delay (OWD) refers to the time taken for a packet to be transmitted across a network from source to destination. It is a common term in IP network monitoring, and differs from round-trip time (RTT) in that only path in the one direction from source to destination is measured.