Search results
Results from the WOW.Com Content Network
In computer science, a data buffer (or just buffer) is a region of memory used to store data temporarily while it is being moved from one place to another. Typically, the data is stored in a buffer as it is retrieved from an input device (such as a microphone) or just before it is sent to an output device (such as speakers); however, a buffer may be used when data is moved between processes ...
The disk buffer is physically distinct from and is used differently from the page cache typically kept by the operating system in the computer's main memory. The disk buffer is controlled by the microcontroller in the hard disk drive, and the page cache is controlled by the computer to which that disk is attached.
USB device pulls up either D+ or D− to wake the host from the detached line state. This starts the USB enumeration process. This sets the idle state. D− pull-up D+ pull-up As full speed, then chirp in reset: Idle / J Host and device transmitter at Hi-Z. Sensing line state in case of detached state. As detached or connect state. Sync
A disk array controller is a device that manages the physical disk drives and presents them to the computer as logical units. It often implements hardware RAID, thus it is sometimes referred to as RAID controller. It also often provides additional disk cache.
Seagate ST11R, an 8-bit ISA RLL hard disk controller produced in 1990. A disk controller is a controller circuit that enables a CPU to communicate with a hard disk, floppy disk or other kind of disk drive. It also provides an interface between the disk drive and the bus connecting it to the rest of the system. [1] [2]
One of the major improvements the PCI Local Bus had over other I/O architectures was its configuration mechanism. In addition to the normal memory-mapped and I/O port spaces, each device function on the bus has a configuration space, which is 256 bytes long, addressable by knowing the eight-bit PCI bus, five-bit device, and three-bit function numbers for the device (commonly referred to as the ...
The digital buffer is important in data transmission between connected systems. Buffers are used in registers (data storage device) and buses (data transferring device). To connect to a shared bus, a tri-state digital buffer should be used, because it has a high impedance ("inactive" or "disconnected") output state (in addition to logic low and ...
One of the device control registers defined by ISA PNP is (for example) the Activate register, which turns the card on or off. [1] The Device Control Register is also the name of a specific register in the PCI Express architecture. It has fields that (among other things) control what is the maximum read request size (in bytes) that the device ...