Ads
related to: drill that punched screw holes in pipe keeps moving on bottom of floortemu.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The most typical reason for tripping pipe is to replace a worn-out drill bit. Though there are many problems that occur to warrant the tripping of pipe. Downhole tools such as MWD (measurement while drilling), LWD (logging while drilling) or mud motors break down quite often. Another common reason for tripping is to replace damaged drill pipe.
Drill pipe (#16) is a joint of hollow tubing used to connect the surface equipment to the bottom hole assembly (BHA) and acts as a conduit for the drilling fluid. In the diagram, these are stands of drill pipe which are 2 or 3 joints of drill pipe connected and stood in the derrick vertically, usually to save time while tripping pipe.
The drill floor is the heart of any drilling rig. This is the area where the drill string begins its trip into the earth. It is traditionally where joints of pipe are assembled, as well as the BHA (bottom hole assembly), drilling bit, and various other tools. This is the primary work location for roughnecks and the driller.
The top drive allows the drilling rig to drill the longer section of a stand of drill pipe in one operation. [1] A rotary table type rig can only drill 30-foot (9.1 m) (single drill pipe) sections of drill pipe whereas a top drive can drill 60–90-foot (18–27 m) stands (double and triple drill pipe respectively, a triple being three joints of drillpipe screwed together), depending on the ...
The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...
Drill cuttings can be separated from liquid drilling fluid by shale shakers, by centrifuges, or by cyclone separators, the latter also being effective for air drilling. In cable-tool drilling, the drill cuttings are periodically bailed out of the bottom of the hole. In auger drilling, cuttings are carried to the surface on the auger flights.
The mousehole is the storage area on a drilling rig where the next joint of drilling pipe is held until needed. This hole is in the floor of the rig, bored into the earth for a short way, and usually lined with a metal casing known as a scabbard. The purpose is to have the top of the piece of drill pipe on a level with the kelly when the time ...
Wireline truck performing pipe recovery on location in Alberta, Canada. Pipe recovery is a specific wireline operation used in the oil and gas industry, when the drill string becomes stuck downhole. Stuck pipe prevents the drill rig from continuing operations. This results in costly downtime, ranging anywhere from $10,000-1,000,000 per day of ...
Ads
related to: drill that punched screw holes in pipe keeps moving on bottom of floortemu.com has been visited by 1M+ users in the past month