enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...

3. Bit shank - Wikipedia

   en.wikipedia.org/wiki/Bit_shank

   A classic "Santa Barbara" style bit shank, designed for western riding and decorated with silver for use at horse shows. The bit shank is the side piece or cheekpiece of a curb bit, part of the bridle, used when riding on horses. The bit shank allows leverage to be added to the pressure of the rider's hands on the bit. Shanks are usually made ...

4. Drill bit shank - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_shank

   For example, this allows a 1 ⁄ 2-inch (13 mm) bit to be used in a pistol-grip drill's 3 ⁄ 8-inch (9.5 mm) chuck. One particular type of reduced-shank drill bits are Silver & Deming (S&D) bits, whose sets run from 9 ⁄ 16-inch (14 mm) to 1 + 1 ⁄ 2-inch (38 mm) drill body diameter with a standard 1 ⁄ 2-inch (13 mm

5. Rabbet - Wikipedia

   en.wikipedia.org/wiki/Rabbet

   A rabbet (American English) or rebate (British English) is a recess or groove cut into the edge of a piece of machinable material, usually wood. When viewed in cross-section, a rabbet is two-sided and open to the edge or end of the surface into which it is cut.

6. Router (woodworking) - Wikipedia

   en.wikipedia.org/wiki/Router_(woodworking)

   Bits also differ by the diameter of their shank, with 1 ⁄ 2-inch, 12 mm, 10 mm, 3 ⁄ 8-inch, 8 mm and 1 ⁄ 4-inch and 6 mm shanks (ordered from thickest to thinnest) being the most common. Half-inch bits cost more but, being stiffer, are less prone to vibration (giving smoother cuts) and are less likely to break than the smaller sizes.

7. Dado (joinery) - Wikipedia

   en.wikipedia.org/wiki/Dado_(joinery)

   A through [1] dado involves cuts which run between both edges of the surface, leaving both ends open. A stopped or blind [2] dado ends before one (stopped) or both (blind) of the cuts meets the edge of the surface. [1] A half dado is formed with a narrow dado cut into one part, coupled with a rabbet of another piece. This joint tends to be used ...