Ads
related to: trickle charge two 12v batteries to make 24vOverall Customer Satisfaction 9.3 out of 10 - Bizrate.com
Search results
Results from the WOW.Com Content Network
[1] [2] A battery under continuous float voltage charging is said to be float-charging. [3] For lead–acid batteries under no-load float charging (such as in SLI batteries), trickle charging happens naturally at the end-of-charge, when the lead–acid battery internal resistance to the charging current increases enough to reduce additional ...
Float voltage is the voltage at which a battery is maintained after being fully charged to maintain that capacity by compensating for self-discharge of the battery. [1] The voltage could be held constant for the entire duration of the cell's operation (such as in an automotive battery) or could be held for a particular phase of charging by the charger. [2]
A trickle charger is typically low-current (usually between 5–1,500 mA). They are generally used to charge small capacity batteries (2–30 Ah). They are also used to maintain larger capacity batteries (> 30 Ah) in cars and boats. In larger applications, the current of the battery charger is only sufficient to provide trickle current.
The actual voltage, matching the car battery's voltage, will be approximately 12.5 volts when dormant (less in cold conditions), approximately 14.5 volts when the engine and the alternator/generator are operating (more when cold), and may briefly drop as low as 5–6 volts during engine start due to the high temporary battery current usage. [12]
The C rate is that which would theoretically fully charge or discharge the battery in one hour. For example, trickle charging might be performed at C/20 (or a "20-hour" rate), while typical charging and discharging may occur at C/2 (two hours for full capacity). The available capacity of electrochemical cells varies depending on the discharge rate.
Example charging graph. On the left: per-cell quantities. On the right: example values for a 40 Ah, 6-cell (12 V) battery. Note: schematic illustration; not based on actual measurements. IUoU is a DIN-designation [1] (DIN 41773) for a lead-acid battery charging procedure that is also known as 3-stage charging, 3-phase charging, or 3-step charging.
Ads
related to: trickle charge two 12v batteries to make 24vOverall Customer Satisfaction 9.3 out of 10 - Bizrate.com