Search results
Results from the WOW.Com Content Network
A cellular repeater (also known as cell phone signal booster or cell phone signal amplifier) is a type of bi-directional amplifier used to improve cell phone reception. [citation needed] A cellular repeater system commonly consists of a donor antenna that receives and transmits signal from nearby cell towers, coaxial cables, a signal amplifier, and an indoor rebroadcast antenna.
A Tower Mounted Amplifier (TMA), or Mast Head Amplifier (MHA), is a low-noise amplifier (LNA) mounted as close as practical to the antenna in mobile masts or base transceiver stations. A TMA reduces the base transceiver station noise figure (NF) and therefore improves its overall sensitivity ; in other words the mobile mast is able to receive ...
Below ground level, large buildings and high rises are examples where mobile phones are unable to properly reach the carrier's macro or outdoor network. In these environments, the in-building cellular enhancement system will connect to the carrier's signal source which is typically a bi-directional amplifier or a base transceiver station.
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
A base transceiver station (BTS) or a baseband unit [1] (BBU) is a piece of equipment that facilitates wireless communication between user equipment (UE) and a network. UEs are devices like mobile phones (handsets), WLL phones, computers with wireless Internet connectivity, or antennas mounted on buildings or telecommunication towers.
The main benefits for an end user are the following: "5 bar" coverage when there is no existing signal or poor coverage; Higher mobile data capacity, which is important if the end-user makes use of mobile data on their mobile phone (may not be relevant to a large number of subscribers who instead use WiFi where femtocell is located)
For an added bonus, the hearing aids offer Bluetooth connectivity for hands-free calls and streaming your favorite music, podcasts and TV shows right to your hearing aid (iPhone 11 or newer ...
In the U.S., the analog AMPS standard that used the cellular band (800 MHz) was replaced by a number of digital systems. Initially, systems based upon the AMPS mobile phone model were popular, including IS-95 (often known as " CDMA ", the air interface technology it uses) and IS-136 (often known as D-AMPS, Digital AMPS, or " TDMA ", the air ...