Search results
Results from the WOW.Com Content Network
Sixteen ohm drivers (or loudspeakers systems) would be connected to the 16-ohm tap, 8 ohm to the 8 ohm tap, etc. This is significant since the ratio between the loudspeaker impedance and the amplifier's impedance at a particular frequency provides damping (i.e., energy absorption) for the back EMF generated by a driver.
American EIA standard RS-299A specifies that (or DCR) should be at least 80% of the rated driver impedance, so an 8-ohm rated driver should have a DC resistance of at least 6.4 ohms, and a 4-ohm unit should measure 3.2 ohms minimum. This standard is voluntary, and many 8-ohm drivers have resistances of ≈5.5 ohms, and proportionally lower for ...
Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...
A given audio amplifier may not be capable of driving this low frequency impedance even though it is capable of driving the nominal impedance, a problem that can be solved either with the use of crossover filters or underrating the amplifier supplied. [26] In the days of valves (vacuum tubes), most loudspeakers had a nominal impedance of 16 Ω ...
The output impedance of a transistorized amplifier is something less than an ohm, but let's take a hypothetical 16 Ohm tube amp instead. 'Nuther safety margin. Connected to this amp, our incredibly capacitive speaker cable will cause, at 20 KHz, the loss of about 16/4000 = 0.4% of the signal.
Speaker wire is a passive electrical component described by its electrical impedance, Z.The impedance can be broken up into three properties which determine its performance: the real part of the impedance, or the resistance, and the imaginary component of the impedance: capacitance or inductance.
The E-202 has a Speaker Damping Control which permits choice of three damping factors and induces maximum potential performance from any speaker. Damping factor with an 8 Ω load becomes more than 50 when this control is set to NORMAL. Likewise, it is 5 at MEDIUM position, and 1 at SOFT position. It enables choosing the speaker sound that one ...
Magnepan has used several different technologies in constructing their magnetostatic speakers.All Magnepan speakers are based on flexible ferrite magnet strips (like refrigerator magnets), 0.060" (1.5 mm) thick, typically cut to either 1/4" (6 mm) wide (mid-bass) or 1/8" (3 mm) wide (tweeters) and more or less the length of the speaker.