Search results
Results from the WOW.Com Content Network
This beam of water is ejected from the nozzle, cutting through the material by spraying it with the jet of speed on the order of Mach 3, around 2,500 ft/s (760 m/s). [39] The process is the same for abrasive waterjets until the water reaches the nozzle. Here abrasives such as garnet and aluminium oxide, are fed into the nozzle via an abrasive ...
The quantity of nozzles must be selected so as to avoid solid accumulating between adjacent nozzles, which can build into the disk stack and disturb its clarification effectiveness. [12] The minimum allowable nozzle size is at least two times bigger than the diameter of the biggest particle to be discharged. [12] Feed
The nozzle opens up in two halves which come together to redirect the exhaust partially forward. Since the nozzle area has an influence on the operation of the engine (see below), the deployed thrust reverser has to be spaced the correct distance from the jetpipe to prevent changes in engine operating limits. [16]
A Piping and Instrumentation Diagram (P&ID) is a detailed diagram in the process industry which shows process equipment together with the instrumentation and control devices.
The example shown is pneumatic. At sub-millimeter distances, a small movement of the flapper plate results in a large change in flow. The nozzle is fed from a chamber which is in turn fed by a restriction, so changes of flow result in changes of chamber pressure. The nozzle diameter must be larger than the restriction orifice in order to work. [2]
Nozzle type and capacity: full cone nozzles have the largest drop size, followed by flat spray nozzles. Hollow cone nozzles produce the smallest drop size. Spraying pressure: drop size increases with lower spraying pressure and decreases with higher pressure. Flow rate: flow rate has a direct effect on drop size.
The 715 shp TPE331-6 used in the Beech King Air B100 have a 400-hr. fuel nozzle cleaning interval, 1,800-hr. hot section inspection interval and a 5,400-hr. time between overhaul; approval is possible for 3,000-hr. HSIs and 6,000-hr. overhauls and engine reserves are cheaper than for the PT6A.
A de Laval nozzle (or convergent-divergent nozzle, CD nozzle or con-di nozzle) is a tube which is pinched in the middle, with a rapid convergence and gradual divergence. It is used to accelerate a compressible fluid to supersonic speeds in the axial (thrust) direction, by converting the thermal energy of the flow into kinetic energy .