Search results
Results from the WOW.Com Content Network
Anchor channels, invented by Anders Jordahl in 1913, are steel channels cast flush in reinforced concrete elements to allow the installation of channel bolts for the fastening of components. Anchor channels consist of steel C-shaped channels and anchors (mostly headed studs ) which are connected to the channel by welding or riveting/forging.
A pipe anchor is a rigid support that restricts movement in all three orthogonal directions and all three rotational directions, i.e. restricting al the 6 degrees of freedom This usually is a welded stanchion that is welded or bolted to steel or concrete. [2] In case of anchor which is bolted to concrete, a special type of bolt is required ...
Other uses include anchoring machines to poured concrete floors [7] and buildings to their concrete foundations. Various typically disposable aids, mainly of plastic, are produced to secure and align cast-in-place anchors prior to concrete placement. Moreover, their position must also be coordinated with the reinforcement layout. [3]
Although flange fittings are bulky, they perform well in demanding applications such as large water supply networks and hydroelectric systems. Flanges are rated at 150, 300, 400, 600, 900, 1500, and 2500 psi; or 10, 15, 25, 40, 64, 100, and 150 bars of pressure. Various types of flanges are available, depending on construction.
The anchor selection, together with additional reinforcement, and rigging arrangements is influenced by: - The dead weight of the element - The number of anchors in the element and the configuration of the anchor - Capacity of the anchor at the specific concrete compressive strengths at time of lift - The dynamic loads applied during lifting ...
Membership on the B16 Standards Committee [1] and its Subordinate groups include a variety of representations from the field in various interest classifications. These interest classifications are; Manufacturer, Distributor, Material Manufacturer, Consumer/User, Designer/Constructor, Regulatory, Insurance/Inspection and General Interest.
An anchor plate, floor plate [1] or wall washer is a large plate or washer connected to a tie rod or bolt. Anchor plates are used on exterior walls of masonry buildings, for structural reinforcement against lateral bowing. Anchor plates are made of cast iron, sometimes wrought iron or steel, and are often made in a decorative style. [2]
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect