Search results
Results from the WOW.Com Content Network
Newer automatic transmission designs often use many pressure control solenoids, and sometimes allow the shift solenoids themselves to provide precise pressure control during shifts by ramping the solenoid on and off. The shift pressure affects the shift quality (too high a pressure will result in rough shifting; too low a pressure will cause ...
In some V8 installations a small control unit activates the kick down solenoid when the brake pedal is released so that the car moves off in 1st gear. Other attributes of this transmission include a 2-3 shift delay when the engine is cold in order to speed up catalyst warm-up. 4th gear is a 1:1 ratio.
A transmission solenoid or cylinoid is an electro-hydraulic valve that controls fluid flow into and throughout an automatic transmission. Solenoids can be normally open or normally closed. They operate via a voltage or current supplied by the transmission computer or controller.
The 4L80-E uses two shift solenoids, initially called Shift Solenoid A and Shift Solenoid B; they were later changed to comply with OBD-II regulations to 1-2 shift solenoid and 2-3 shift solenoid. By activating and deactivating the solenoids in a predetermined pattern by the PCM, four distinct gear ratios can be achieved.
Pushing a button on the shift control preselected the chosen gear. The electrical circuit was closed only after the driver fully depressed the clutch pedal. This energized the appropriate transmission mounted solenoids necessary for returning the transmission to neutral and then completing engagement of the preselected gear.
While the AOD and AOD-E are like each other (oil pans, casings, bellhousing, and internals), they are not interchangeable with each other, because the AOD-E's shift points are controlled electronically from a combination of solenoids and the Powertrain Control Module (PCM), while the AOD's shift points are hydraulically controlled by a throttle ...
Toyota brands the K120 as the “Direct Shift” CVT and includes a physical first gear (also known as a "launch gear") and nine additional simulated gears, for a total of 10. The launch gear is engaged when the vehicle takes off from being stopped and transitions to the belt drive as the vehicle picks up speed.
A direct-shift gearbox (DSG, German: Direktschaltgetriebe [1]) [2] [3] is an electronically controlled, dual-clutch, [2] multiple-shaft, automatic gearbox, in either a transaxle or traditional transmission layout (depending on engine/drive configuration), with automated clutch operation, and with fully-automatic [2] or semi-manual gear selection.