Search results
Results from the WOW.Com Content Network
Mill scale is a complex oxide that contains around 70% iron with traces of nonferrous metals and alkaline compounds. Reduced iron powder may be obtained by conversion of mill scale into a single highest oxide i.e. hematite (Fe 2 O 3) followed by reduction with hydrogen.
Weathering steel, often referred to by the genericised trademark COR-TEN steel and sometimes written without the hyphen as corten steel, is a group of steel alloys that form a stable external layer of rust that eliminates the need for painting. U.S. Steel (USS) holds the registered trademark on the name COR-TEN. [1]
Common sizes of corrugated material can range from a very thin 30 gauge (0.012 inches, 0.3 mm) to a relatively thick 6 gauge (0.1943 inches, 5 mm). Thicker or thinner gauges may also be produced. Other materials such as thermoplastic and fiberglass-reinforced plastic sheets are also produced with corrugations. Clear or translucent products can ...
Download as PDF; Printable version; In other projects ... Modell railroads in 3 mm scale (3 mm to 1 foot scale with a scale ratio of 1:101). Pages in category "3 mm ...
When H0 scale was being introduced, the motors available were too large [4] to fit in scale-sized bodies and so as a compromise the scale was increased from 3.5 mm to 4 mm to the foot, but the gauge was not changed so other elements could be shared. For 00 therefore the track is about 12.5% narrower than it should be for the scale used.
Sheet metal is available in flat pieces or coiled strips. The coils are formed by running a continuous sheet of metal through a roll slitter. In most of the world, sheet metal thickness is consistently specified in millimeters. In the U.S., the thickness of sheet metal is commonly specified by a traditional, non-linear measure known as its ...
Due to Scale creep, modern 30 mm figures may be similar to 1:64 models , but appear larger due to bulky sculpting and thick bases. At an exact scale of 1:60 (30.48 mm), it matches common battlemap grids where 1 inch represents 5 feet. 32 mm: ≈5.7 mm: ≈1:54: Heroic scale of 30 mm miniatures. Currently, the most common size of miniature figures.
The sides were corrugated steel sheets, and the two ends were covered with plywood which had doors and windows. The interior was insulated and had pressed wood lining and a wood floor. The building could be placed on concrete, on pilings, or directly on the ground with a wood floor. The original design used low-grade steel, which was later ...