enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Crimp (joining) - Wikipedia

   en.wikipedia.org/wiki/Crimp_(joining)

   Crimp tool for 0.14 mm 2 to 10 mm 2 (26–8 AWG) insulated and non-insulated ferrules. Crimping is a method of joining two or more pieces of metal or other ductile material by deforming one or both of them to hold the other. The bend or deformity is called the crimp. [1] [2] Crimping tools are used to create crimps.

3. IDC (electrical connector) - Wikipedia

   en.wikipedia.org/wiki/IDC_(electrical_connector)

   Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.

4. Twist-on wire connector - Wikipedia

   en.wikipedia.org/wiki/Twist-on_wire_connector

   Twist-on wire connectors are not generally recommended for use with aluminum wire in the United States. [1] The U.S. Consumer Product Safety Commission disapproves wire nuts for aluminum wire; instead, special crimp connectors are called for, and as of 2011 the CPSC asserted qualified, second-preference approval of a certain kind of screw ...

5. FASTON terminal - Wikipedia

   en.wikipedia.org/wiki/FASTON_terminal

   PLASTI-GRIP (Vinyl) (insulation restricting) terminals are defined in AMP Specification 114-1003: Terminal, FASTON, PLASTI-GRIP, Application of; UL 310 "Standard for Electrical Quick-Connect Terminals" [4] CSA 22.2 #153, "Quick-Connect Terminals" UL 486 also specifies the testing of standard wire connectors and soldering lugs. MIL-T-7928

6. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Since stripping insulation from wires is time-consuming, many connectors intended for rapid assembly use insulation-displacement connectors which cut the insulation as the wire is inserted. [1] These generally take the form of a fork-shaped opening in the terminal, into which the insulated wire is pressed, which cut through the insulation to ...

7. Hose clamp - Wikipedia

   en.wikipedia.org/wiki/Hose_clamp

   The clamp is placed over the end of the hose or tube to be connected and when each ear is closed at the base of the ear with a special pincer tool, it permanently deforms, pulling the band, and causing the band to tighten around the hose. The size of clamp should be chosen such that the ear(s) are almost completely closed on installation.