enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Low-noise block downconverter - Wikipedia

    en.wikipedia.org/wiki/Low-noise_block_downconverter

    A universal LNB has a switchable local oscillator frequency of 9.75/10.60 GHz to provide two modes of operation: low band reception (10.70–11.70 GHz) and high band reception (11.70–12.75 GHz). The local oscillator frequency is switched in response to a 22 kHz signal superimposed on the supply voltage from the connected receiver.

  3. Wideband - Wikipedia

    en.wikipedia.org/wiki/Wideband

    In communications, a system is wideband when the message bandwidth significantly exceeds the coherence bandwidth of the channel.Some communication links have such a high data rate that they are forced to use a wide bandwidth; other links may have relatively low data rates, but deliberately use a wider bandwidth than "necessary" for that data rate in order to gain other advantages; see spread ...

  4. List of UWB channels - Wikipedia

    en.wikipedia.org/wiki/List_of_UWB_channels

    TFCs 1-4 are for TFI channels, TFCs 5-7 are for FFI channels, and TFCs 8-10 are for TFI2 channels, which simply interleave their data across two bands. Note that all TFCs will be in the same band at some time during their sequence. TFC numbering of 1-10 repeats for each band group and these TFC numbers are primarily used by the MAC and PHY layers.

  5. Single-cable distribution - Wikipedia

    en.wikipedia.org/wiki/Single-cable_distribution

    Special LNBs have been developed for use in single-cable distribution systems. All four sub-bands of the Ku band (low frequency/horizontal polarity, high frequency/horizontal polarity, low frequency/vertical polarity, high frequency/vertical polarity) are received by a conventional front end, amplified and downconverted to the L-band, to be fed to a number of SatCR (Satellite Channel Router ...

  6. Intermediate frequency - Wikipedia

    en.wikipedia.org/wiki/Intermediate_frequency

    In the box at the focus of the dish, called a low-noise block downconverter (LNB), each block of frequencies is converted to the IF range of 950–2150 MHz by two fixed frequency local oscillators at 9.75 and 10.6 GHz. One of the two blocks is selected by a control signal from the set top box inside, which switches on one of the local oscillators.

  7. UWB ranging - Wikipedia

    en.wikipedia.org/wiki/UWB_ranging

    The sub-gigahertz band, which contains only 1 channel and ranges from 249.6 MHz to 749.6 MHz. The low band, which contains 4 channels and ranges from 3.1 GHz to 4.8 GHz. The high band, which contains 11 channels and ranges from 6.0 GHz to 10.6 GHz. The primary time division in UWB systems is structured in frames. Each frame is composed by the ...

  8. Monoblock LNB - Wikipedia

    en.wikipedia.org/wiki/Monoblock_LNB

    In Europe, for example, there are monoblock single, twin, and quad LNBs for the K u band, which have a pre-defined spacing of 6 degrees (for Astra 19.2°E/Hot Bird 13°E). In March 2007, a new type of monoblock, called the Duo LNB was introduced by CanalDigitaal in the Netherlands for the simultaneous reception of Astra 19.2°E / Astra 23.5°E ...

  9. Block upconverter - Wikipedia

    en.wikipedia.org/wiki/Block_upconverter

    BUCs used in remote locations are often 2 or 4 W in the K u band and 5 W in the C band. The 10 MHz reference frequency is usually sent on the same feedline as the main carrier. Many smaller BUCs also get their direct current (DC) over the feedline, using an internal DC block. BUCs are generally used in conjunction with low-noise block ...