Search results
Results from the WOW.Com Content Network
Under zero- or reverse-bias (the "off" state), a PIN diode has a low capacitance. The low capacitance will not pass much of an RF signal. Under a forward bias of 1 mA (the "on" state), a typical PIN diode will have an RF resistance of about 1 ohm, making it a good conductor of RF. Consequently, the PIN diode makes a good RF switch.
A PIN diode has a central un-doped, or intrinsic, layer, forming a p-type/intrinsic/n-type structure. [42] They are used as radio frequency switches and attenuators. They are also used as large-volume, ionizing-radiation detectors and as photodetectors. PIN diodes are also used in power electronics, as
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
MELF: Metal electrode leadless face (usually for resistors and diodes) SOD: Small-outline diode. SOT: Small-outline transistor (also SOT-23, SOT-223, SOT-323). TO-XX: wide range of small pin count packages often used for discrete parts like transistors or diodes. TO-3: Panel-mount with leads; TO-5: Metal can package with radial leads
These characteristics are also known as I–V curves, referring to the standard symbols for current and voltage. In electronic components with more than two terminals, such as vacuum tubes and transistors, the current–voltage relationship at one pair of terminals may depend on the current or voltage on a third terminal. This is usually ...
Three 1N4148 diodes in glass DO-35 axial package. The black band on the right is the cathode side. Diode schematic symbol vs cathode marking on the package. The 1N4148 is a standard silicon switching signal diode. It is one of the most popular and long-lived switching diodes because of its dependable specifications and low cost.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Zener diodes have a low breakdown voltage. A standard value for breakdown voltage is for instance 5.6 V. This means that the voltage at the cathode cannot be more than about 5.6 V higher than the voltage at the anode (though there is a slight rise with current), because the diode breaks down, and therefore conducts, if the voltage gets any higher.