Ads
related to: 3 pin plug wiring
Search results
Results from the WOW.Com Content Network
Double insulated appliances may omit the earth pin. When viewing a plug from the rear, and the earth pin downwards, the top left pin is active and the top right pin is neutral. The shank of the active and neutral pins of every 10 amp and 15 amp flat-pin plug sold after 3 April 2005 are required to be insulated, in accordance with AS/NZS 3112: ...
In 1885, two-pin plug designs appeared and in 1889 there were two-pin plugs and sockets in the GEC catalogue. [28] The 1893 GEC Catalogue included three sizes of what was described as Double plug Sockets with capacities described not in amps, but as "1 to 5 lights", "5 to 10 lights" and "10 to 20 lights".
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
Three-prong plugs do not fit into the older, two-prong receptacles. [7] When used as intended, the ground pin of the 3-wire receptacle is to be connected to a grounded cover screw, or to an external ground. In 1969, Underwriters Laboratories mandated three-prong plugs on major appliances for safety. [7]
There are two types of sockets and plugs in NBR 14136: one for 10 A, with a 4.0 mm pin diameter, and another for 20 A, with a 4.8 mm pin diameter. [13] This differs from IEC 60906-1 which specifies a pin diameter of 4.5 mm and a rating of 16 A. NBR 14136 does not require shutters on the apertures, a further aspect of non-compliance with IEC ...
This diagram shows the wiring of a British type G three pin plug. Externally it looks like this:en:Image:G plug.jpg: Date: 23 April 2011: Source: Traced from File:Three pin mains plug (UK).png: Author: Slashme: Other versions {Three pin mains plug (UK).png:
Ads
related to: 3 pin plug wiring