enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. UHF connector - Wikipedia

   en.wikipedia.org/wiki/UHF_connector

   Virtually all of the impedance bump and loss is in the UHF female. A typical SO-239 UHF female, properly hooded, has an impedance bump of about 35 ohms. The length of the bump is typically 1 ⁄ 2 inch, where the female pin flares to fit over the male pin. This bump can be mitigated by using a honeycomb dielectric in the female pin area.

3. List of video connectors - Wikipedia

   en.wikipedia.org/wiki/List_of_video_connectors

   Replaced by F connector in North America and Belling-Lee Connector in other countries outside North America. UHF connector (e.g. PL-259/SO-239) Despite its name, now most commonly seen on higher-power HF radio equipment, e.g. SSB transceivers. A popular choice for amateur radio enthusiasts. 50 Ω

4. List of RF connector types - Wikipedia

   en.wikipedia.org/wiki/List_of_RF_connector_types

   LEMO 00 connector, a proprietary push-pull 50 Ω coaxial connector; MCX connector; Microdot S-50 series connector, a proprietary 50 Ω coaxial connector; Mini-BNC connector; Mini-UHF connector, a smaller and much newer design than the standard UHF; SMA connector A 50 ohm screwed connection. The 0.9mm centre pin is the same diameter as the ...

5. F connector - Wikipedia

   en.wikipedia.org/wiki/F_connector

   The F connector is an inexpensive, gendered, threaded, compression connector for radio frequency signals. It has good 75 Ω impedance match for frequencies well over 1 GHz [2] and has usable bandwidth up to several GHz. Connectors mate using a 3/8-32UNEF thread. The female connector has a socket for the center conductor and external threads.

6. N connector - Wikipedia

   en.wikipedia.org/wiki/N_connector

   Type N connector (female) The N connector (also, type-N connector) is a threaded, weatherproof, medium-size RF connector used to join coaxial cables.It was one of the first connectors capable of carrying microwave-frequency signals, and was invented in the 1940s by Paul Neill of Bell Labs, after whom the connector is named.

7. Belling-Lee connector - Wikipedia

   en.wikipedia.org/wiki/Belling-Lee_connector

   Female Belling-Lee connector on a television set. The Belling-Lee connector (also type 9,52, but largely only in the context of its specification, IEC 61169, Part 2: Radio-frequency coaxial connector of type 9,52) [1] is commonly used in Europe, parts of Southeast Asia, and Australia, to connect coaxial cables with each other and with terrestrial VHF/UHF roof antennas, antenna signal ...