enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Clamp holder - Wikipedia

   en.wikipedia.org/wiki/Clamp_holder

   Clamp holders can secure laboratory equipment at specific angles, diameters, and weights, as required. [3] Clamp holders are often used to hold the attached apparatus over a work surface. There are several different types of holders, such as swivel holders and all-position holders, that allow adjustments for different angles and planes. In some ...

3. Machine taper - Wikipedia

   en.wikipedia.org/wiki/Machine_taper

   The R8 system is commonly used with collets ranging in size from 1 ⁄ 8 ″ to 3 ⁄ 4 ″ in diameter or tool holders with the same or slightly larger diameters. The collets or tool holders are placed directly into the spindle and the drawbar is tightened into the top of the collet or tool holder from above the spindle.

4. Pocket-hole joinery - Wikipedia

   en.wikipedia.org/wiki/Pocket-hole_joinery

   When joining boards at a right angle, it is important that the cuts are precise and square to prevent gaps or un-perpendicular joints between the boards. Some woodworkers lay out their project before drilling their pocket holes and mark the face of the board that they want to drill to ensure the hole is in the correct location.

5. Gimlet (tool) - Wikipedia

   en.wikipedia.org/wiki/Gimlet_(tool)

   A gimlet is a hand tool for drilling small holes, mainly in wood, without splitting. It was defined in Joseph Gwilt's Architecture (1859) as "a piece of steel of a semi-cylindrical form, hollow on one side, having a cross handle at one end and a worm or screw at the other". [1] A gimlet is always a small tool.

6. Drill bit - Wikipedia

   en.wikipedia.org/wiki/Drill_bit

   The correct tool to start a traditionally drilled hole (a hole drilled by a high-speed steel (HSS) twist drill bit) is a spotting drill bit (or a spot drill bit, as they are referenced in the U.S.). The included angle of the spotting drill bit should be the same as, or greater than, the conventional drill bit so that the drill bit will then ...

7. Screwdriver - Wikipedia

   en.wikipedia.org/wiki/Screwdriver

   A typical simple screwdriver has a handle and a shaft, ending in a tip the user puts into the screw head before turning the handle. This form of the screwdriver has been replaced in many workplaces and homes with a more modern and versatile tool, a power drill, as they are quicker, easier, and can also drill holes. The shaft is usually made of ...