enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Integrated Motor Assist - Wikipedia

   en.wikipedia.org/wiki/Integrated_Motor_Assist

   Integrated Motor Assist (commonly abbreviated as IMA) is Honda's hybrid car technology, introduced in 1999 on the Insight. It is a specific implementation of a parallel hybrid. It uses an electric motor mounted between the internal combustion engine and transmission to act as a starter motor, power generator, engine balancer, and assist ...

3. Turbo generator - Wikipedia

   en.wikipedia.org/wiki/Turbo_generator

   The rotor of a turbo generator is a non-salient pole type usually with two poles. [5] The normal speed of a turbo generator is 1500 or 3000 rpm with four or two poles at 50 Hz (1800 or 3600 rpm with four or two poles at 60 Hz). The rotating parts of a turbo generator are subjected to high mechanical stresses because of the high operation speed.

4. Honda - Wikipedia

   en.wikipedia.org/wiki/Honda

   The five models are: 2000–2006 Honda Insight (53 mpg ‑US or 4.4 L/100 km or 64 mpg ‑imp combined), 1986–1987 Honda Civic Coupe HF (46 mpg ‑US or 5.1 L/100 km or 55 mpg ‑imp combined), 1994–1995 Honda Civic hatchback VX (43 mpg ‑US or 5.5 L/100 km or 52 mpg ‑imp combined), 2006– Honda Civic Hybrid (42 mpg ‑US or 5.6 L/100 ...

5. Rolls-Royce WR-21 - Wikipedia

   en.wikipedia.org/wiki/Rolls-Royce_WR-21

   Twin-spool gas generator and free-rotating power turbine. Low-pressure (LP) spool with six-stage compressor and single-stage turbine at 6,200 rpm; High-pressure (HP) spool with six-stage compressor and single-stage turbine at 8,100 rpm; Five-stage free power turbine 3,600 rpm (60 Hz) Intercooler between LP and HP compressors; Nine radial combustors

6. Hydrogen-cooled turbo generator - Wikipedia

   en.wikipedia.org/.../Hydrogen-cooled_turbo_generator

   The bearings have to be leak-tight. A hermetic seal, usually a liquid seal, is employed; a turbine oil at pressure higher than the hydrogen inside is typically used. A metal, e.g. brass, ring is pressed by springs onto the generator shaft, the oil is forced under pressure between the ring and the shaft; part of the oil flows into the hydrogen side of the generator, another part to the air side.

7. What should you set your heat to in the winter? Avoid ... - AOL

   www.aol.com/set-heat-winter-avoid-thermostat...

   What you should set your thermostat at in the winter. Turns out there's a magic number for your thermostat setting in the winter, experts say. That setting? 68 degrees, according to the Energy ...