Search results
Results from the WOW.Com Content Network
Block diagram of a superheterodyne receiver. The RF front end consists of the components on the left colored red. In a radio receiver circuit, the RF front end, short for radio frequency front end, is a generic term for all the circuitry between a receiver's antenna input up to and including the mixer stage. [1]
The RF signal from the antenna may have one stage of amplification to improve the receiver's noise figure, although at lower frequencies this is typically omitted. The RF signal enters a mixer, along with the output of the local oscillator, in order to produce a so-called intermediate frequency (IF) signal. An early optimization of the ...
Block diagram of TRF receiver. The classic TRF receivers of the 1920s and 30s usually consisted of three sections: one or more tuned RF amplifier stages. These amplify the signal of the desired station to a level sufficient to drive the detector, while rejecting all other signals picked up by the antenna.
English: Block diagram of a tuned radio frequency (TRF) receiver, the simplest type of amplifying radio receiver circuit. It consists of one or more tuned RF amplifiers, each consisting of a tuned circuit which functioned as a bandpass filter followed by a radio frequency (RF) amplifier; a detector (demodulator) to extract the audio waveform from the radio carrier wave; followed by an audio ...
The RF front end of the receiver is often cryogenically cooled to −195.79 °C (−320 °F) by liquid nitrogen to reduce radio noise in the circuit. Remote control - Remote control receivers receive digital commands that control a device, which may be as complex as a space vehicle or unmanned aerial vehicle, or as simple as a garage door opener.
It consisted of one or more tuned RF amplifiers, each consisting of a tuned circuit which functioned as a bandpass filter followed by an amplifier; a detector (demodulator) to extract the audio waveform from the radio carrier wave; followed by an audio amplifier.
In a radio antenna, the feed line (feedline), or feeder, is the cable or other transmission line that connects the antenna with the radio transmitter or receiver.In a transmitting antenna, it feeds the radio frequency (RF) current from the transmitter to the antenna, where the energy in the current is radiated as radio waves.
Atheros Intellon 1200 AFE-Chip as companion for an INT 5500 PowerLine-IC. An analog front-end (AFE or analog front-end controller AFEC) is a set of analog signal conditioning circuitry that uses sensitive analog amplifiers, often operational amplifiers, filters, and sometimes application-specific integrated circuits for sensors, radio receivers, and other circuits to provide a configurable and ...