Ad
related to: installing a rudder on kayak wheel lock assembly tool system
Search results
Results from the WOW.Com Content Network
Typical trim tabs on aileron, rudder and elevator. Trim tabs are small surfaces connected to the trailing edge of a larger control surface on a boat or aircraft, used to control the trim of the controls, i.e. to counteract hydro- or aerodynamic forces and stabilise the boat or aircraft in a particular desired attitude without the need for the operator to constantly apply a control force.
The Braine steering gear was a fine-tuned system of quadrant on the rudder stock driven by the tension of the mainsail sheet and damped by a rubber band. A more sophisticated system called the vane gear was later devised, it relied on a small vane or airfoil driving the main rudder via an adjustable system
A wheel hub with a castellated nut secured in the center using a cotter pin to prevent it from unscrewing. A positive locking device is a device used in conjunction with a fastener in order to positively lock the fastener. This means that the fastener cannot work loose from vibrations. The following is a list of positive locking devices: [1] A ...
Gust lock on a rudder. A gust lock on an aircraft is a mechanism that locks control surfaces and keeps open aircraft doors in place while the aircraft is parked on the ground and non-operational. Gust locks prevent wind from causing unexpected movements of the control surfaces and their linked controls inside the aircraft, as well as aircraft ...
The rudder attaches to the skeg and is steered by cables attached to it. In select sweeping boats, typically fours and eights, a coxswain will control the rudder, while in sculling boats and some sweeping boats, especially pairs, the rudder will be controlled with toe-steering. [4] A skeg typically consists of a flat piece of metal or plastic. [5]
An anti-servo tab on the elevator of an American Aviation AA-1 Yankee. An anti-servo tab, or anti-balance tab, works in the opposite way to a servo tab. It deploys in the same direction as the control surface, making the movement of the control surface more difficult and requires more force applied to the controls by the pilot.
The family of Tennessee death row inmate Gary Wayne Sutton held a press conference asking Gov. Bill Lee to examine the case for a potential pardon.
Bellcranks are often used in aircraft flight control systems to connect the pilot's controls to the control surfaces. For example, on light aircraft, the rudder often has a bellcrank (also called a control horn) whose pivot point is the rudder hinge. A cable connects one of the pilot's rudder pedal to one side of the bellcrank.
Ad
related to: installing a rudder on kayak wheel lock assembly tool system