Search results
Results from the WOW.Com Content Network
The inline six-cylinder 71 series engine was introduced as the initial flagship product of the Detroit Diesel Engine Division of General Motors in 1938.. This engine was in high demand during WWII, necessitating a dramatic increase in output: about 57,000 6-71s were used on American landing craft, including 19,000 on LCVPs, about 8,000 on LCM Mk 3, and about 9,000 in quads on LCIs; and 39,000 ...
The 6-71 is an inline six cylinder diesel engine. [1] The 71 refers to the displacement in cubic inches of each cylinder. [1] The firing order of the engine is 1-5-3-6-2-4. [1] The engine's compression ratio is 18.7:1 with a 4.250 inch bore and a 5.00 inch stroke. [1]
The GM Diesel/Detroit Diesel model 6051 Quad power pack consists of four inline 2-stroke diesel 6-71 engines mounted to one gearbox, usually with one shaft coming out of the power unit. The power units were fitted on landing craft and ships during World War II , ships including LCI(L) , [ 1 ] Prab (741) and Nahka (751) were fitted with two of ...
The Series 92 engines were introduced in 1974. [8] Compared to the Series 71 engines they were derived from, the Series 92 featured a larger bore of 4.84025 ± 0.00125 in (122.942 ± 0.032 mm) and an identical stroke of 5 in (130 mm) for a nominal displacement per cylinder of 92 cu in (1,510 cc), from which the Series 92 derives its name.
Most "old-look" buses were powered with the Detroit Diesel 6-71 inline six-cylinder diesel engine, the exceptions being the shorter models that were powered by the Detroit Diesel 4-71, a four-cylinder version of the same diesel engine, and buses that were equipped with gasoline engines. Manual and automatic transmissions were available.
In February 1900, this engine ran under its own power for the first time. However, with its actual power output of only 6.95 PS (5 kW; 7 hp) and high fuel consumption of 380 g·PS −1 ·h −1 (517 g·kW −1 ·h −1), it did not prove to be successful; [4] Güldner's two-stroke diesel engine project was abandoned in 1901. [5]
He moved to Detroit in 1936, and was a central figure in the development of the 567 and the Detroit Diesel 6-71. He moved to EMD in 1938, became chief engineer at EMD in 1948, then division director in 1956 and subsequently research assistant to the general manager in 1958 until his retirement in 1960. [ 2 ]
Brake-specific fuel consumption (BSFC) was a notable issue, which at 1.63 lb/hp·h [19] was significantly greater than that of a comparable Detroit Diesel 8V71 diesel engine (approximately 0.40 lb/hp·h), [20] even though the turbine was 1,500 lb (680 kg) lighter. Other planned improvements would target throttle lag, which was caused by ...