Search results
Results from the WOW.Com Content Network
calorie (International Table) cal IT: ≡ 4.1868 J = 4.1868 J: calorie (mean) cal mean: 1 ⁄ 100 of the energy required to warm one gram of air-free water from 0 °C to 100 °C at a pressure of 1 atm ≈ 4.190 02 J: calorie (thermochemical) cal th: ≡ 4.184 J = 4.184 J: Calorie (US; FDA) Cal ≡ 1 kcal = 1000 cal = 4184 J: calorie (3.98 °C ...
In direct current (DC) circuits, this product is equal to the real power, measured in watts. [3] The volt-ampere is dimensionally equivalent to the watt: in SI units, 1 V⋅A = 1 W. VA rating is most used for generators and transformers, and other power handling equipment, where loads may be reactive (inductive or capacitive).
For reference, about 10,000 100-watt lightbulbs or 5,000 computer systems would be needed to draw 1 MW. Also, 1 MW is approximately 1360 horsepower. Modern high-power diesel-electric locomotives typically have a peak power of 3–5 MW, while a typical modern nuclear power plant produces on the order of 500–2000 MW peak output.
In the domain of energy storage and conversion technologies, such as batteries, fuel cells, motors, and power supply units, power density is a crucial consideration. Here, power density often refers to the volume power density, quantifying how much power can be accommodated or delivered within a specific volume (W/m 3 ).
The base value should only be a magnitude, while the per-unit value is a phasor. The phase angles of complex power, voltage, current, impedance, etc., are not affected by the conversion to per unit values. The purpose of using a per-unit system is to simplify conversion between different transformers.
Electric power is the rate of transfer of electrical energy within a circuit.Its SI unit is the watt, the general unit of power, defined as one joule per second.Standard prefixes apply to watts as with other SI units: thousands, millions and billions of watts are called kilowatts, megawatts and gigawatts respectively.
Heat engines are able to convert thermal energy in the form of a temperature gradient between a hot source and a cold sink into other desirable mechanical work. Heat pumps take mechanical work to regenerate thermal energy in a temperature gradient. Standard definitions should be used when interpreting how the propulsive power of a jet or rocket ...
Nameplate capacity, also known as the rated capacity, nominal capacity, installed capacity, maximum effect or gross capacity, [1] is the intended full-load sustained output of a facility such as a power station, [2] [3] electric generator, a chemical plant, [4] fuel plant, mine, [5] metal refinery, [6] and many others.